Advertisement
1a. Mount on Wood Stud Wall
• Make sure that mounting screws are anchored into the center of the studs. Use of a stud finder
is highly recommended.
• Installers are responsible to provide hardware for other types of mounting situations.
• Installers must verify that the supporting surface will safely support the combined load of the
equipment and all attached hardware and components.
3
55mm
55mm
(2.2")
(2.2")
ø 4.5mm
(ø 3/16")
1
Find and mark the
exact location of
mounting holes
√
W-C
W-A
WARNING
1b. Mount on Solid Brick and Concrete Block
2
3
Drill pilot holes
X
X
Screw the wall
mount onto
the wall
• When installing wall mounts on cinder block, verify the actual concrete thickness is at least
1-3/8" (35mm) for using the concrete anchors. Do not drill into mortar joints! Be sure to
mount in a solid part of the block, generally 1" (25mm) minimum from the side of the block.
It is suggested electric drill on slow setting is used to drill the hole instead of a hammer drill
to avoid breaking out the back of the hole when entering a void or cavity.
• Installers must verify that the supporting surface will safely support the combined load of the
equipment and all attached hardware and components.
60mm
60mm
(2.4")
(2.4")
ø 10mm
(ø 3/8")
1
exact location of
mounting holes
2
Drill pilot holes
√
W-B
W-C
W-A
WARNING
Mark the
X
X
Screw the wall
mount onto
the wall
4
Advertisement
