Advertisement
Step 1
Pole/Stand Assembly
Single: Insert the pole into the stand and tighten set screw in back of stand using the
7/32 allen wrench.
Double: Follow above step, insert the second pole inside the fi rst pole at preferred height
and tighten the set screws with the 3/32" allen wrench that is provided.
Single
Set
Screw
Step 1A
Collar Adjustments
Loosen the knob on the back of the collar so that the collar is able to slide up or down. Find
the desired height and re-tighten the knob.
*If you are assembling the Double, do this for both upper and lower knobs.
Double
Set
Screw
Tension
Knob
Step 3
VESA Bracket & Tilt Mechanism Assembly
Carefully remove the base from the fl at panel monitor. (See your monitor's User's Guide
for instructions on how to do this.)
Attach the adapter plate (75MM or 100MM) to the tilter mechanism, using four (4)
10-32 x 3/8" Flat Head Philips screws.
Please contact our customer service department at 800.524.2744 or sales@LCDARMS.com
if your monitor is not VESA compliant.
Step 4
Attach Tilter/VESA bracket to the monitor
Align the tilter and VESA bracket with the hole pattern on the back of the monitor.
Use the four (4) M4-12 Philips Pan Head screws to attach the plate to the back of the LCD.
Advertisement
