Advertisement

IDEAL PRAKTIK MIG 200 IGBT MMA
INSTRUCTIONS MANUAL
WARNING! FOR SAFETY REASON PLEASE READ AND UNDERSTAND
THE FOLLOWING INSTRUCTIONS BEFORE FIRST USE OF THE DEVICE.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PRAKTIK MIG 200 IGBT MMA and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for IDEAL PRAKTIK MIG 200 IGBT MMA

  • Page 1 IDEAL PRAKTIK MIG 200 IGBT MMA INSTRUCTIONS MANUAL WARNING! FOR SAFETY REASON PLEASE READ AND UNDERSTAND THE FOLLOWING INSTRUCTIONS BEFORE FIRST USE OF THE DEVICE.
  • Page 2: General Instructions

    1. General instructions Read the operating instructions! The operating instructions provide an introduction to the safe use of the products. An incorrectly performed installation can result in material damage and injure persons as a result. For this reason, we do not accept any responsibility or liability for losses, damages or costs arising from incorrect installation, improper operation or incorrect usage and maintenance or any actions connected to this in any way.
  • Page 3: Safety Instructions

    2. Safety instructions DANGER! Electromagnetic fields! The power source may cause electrical or electromagnetic fields to be produced which could affect the correct functioning of electronic equipment such as IT or CNC devices, telecommunication lines, power cables, signal lines and pacemakers. •...
  • Page 4 WARNING! Smoke and gases! Smoke and gases can lead to breathing difficulties and poisoning. In addition, solvent vapour (chlorinated hydrocarbon) may be converted into poisonous phosgene due to the ultraviolet radiation of the arc! • Ensure that there is sufficient fresh air! •...
  • Page 5 CAUTION! Installation site! The machine must not be operated in the open air and must only be set up and operated on a suitable, stable and level base! • The operator must ensure that the ground is non-slip and level, and provide sufficient lighting for the place of work.
  • Page 6 1. Technical specification Power supply AC 230V / 50Hz (1ph) Welding processes MIG, MAG, MMA Technology IGBT Welding current MIG/MAG 30A - 200A Welding current MMA 180A Duty cycle 100% (130A) / 60% (180A) Current regulation Stepless (fluent) No load voltage Power consumption 5.2 kW Wire spool weight...
  • Page 7 Preparing the device to work Before use please make sure that electric network you are going to use is corresponding to technical specification of the device. Power supply voltage and frequency is provided in the technical specification section of this manual. Please check if the power supply connection is grounded.
  • Page 8 Turn the device ON. Adjust the downforce of the feed roller by turning the pressure knob. Too low contact force, cause there will be a sliding of the drive roller. Too much force increases the resistance in the feeder and can deform the wire. 7.
  • Page 9: Troubleshooting

    The penetration depth can differ according to welding technique and torch position H1, H2 – penetration depth 10. Welding using MMA process The welding device can also be used for a stick electrode welding. To use that process turn the MIG/TIG/MMA switch to MMA position.
  • Page 10 13. Transporting and storage Always store the devices in a dry, ventilated place, out of reach of children and bystanders. Protect the device against vibrations and shocks during transport. 14. Recycling The packaging and device materials are suitable for recycling use. Disposal of the packaging and device must be done in accordance with local regulations.

Table of Contents