Advertisement
Available languages
Available languages
PRODUCT SPECIFICATIONS:
Brand name
Model number
Gas type
Cylinder size
Ignition
Regulator
(kpa)
Operating pressure
Max gas
consumption
Heat capacity
Electric Output
Weight(kg)
Boxed Size(lxbxh)
For indoor use only
Regulator and hose supplied. Replace only with a SANS 1237
approved regulator and SANS1156 or 853212 approved hose.
IF YOU SMELL GAS:
•
Turn off gas supply at bottle
•
Extinguish all naked flames;
•
Do not operate any electrical appliances
•
Ventilate the area
•
Check for leaks as detailed in this manual
If odour persists, contact your dealer or gas supplier
immediately
BURN-BACK (FIRE IN BURNER TUBE OR CHAM-
BER)
In the event of a burn-back, where the flame burns
back to the jet, immediately turn the gas supply off
at the control valve on the panel. After ensuring the
flame is extinguished, wait for I minute and relight
the appliance in the normal manner. Should the ap-
pliance again burn back, close the control valve
and call a service technician. Do not use the appli-
ance again until the service technician has declared
that it is safe to do so.
GAS-PRESSURE REGULATOR
This appliance requires an operating pressure of 2,8
kPa at the appliance. A suitable LPG regulator that
complies with the requirements of SANS 1237 must
be installed.
IMPORTANT INFORMATION FOR THE USER
This appliance may only be installed by a registered
SAQCC Gas installer. All registered installers
are issued with a card carrying their registration
Taurus
947183
LPG only
9kg cylinder only
Piezo ignition
0.59mm
+ -
Outlet
2.8 0.5
Inlet
80~700
2.8kPa
0.375kg/h
Max
4.2 kW
Med
2.8kW
Min
1.4kW
1200W
11kg
420x150x695mm
number. Ask to be shown the card before allowing
the
installation work to commence and make a note of
the Installer registration number. Upon completion
of the installation, the installer is required to explain
the operational details of the appliance together
with the safety instructions. You will be asked to sign
acceptance of the installation and be provided
with a completion certificate. You should only sign
for acceptance of the installation when the
installation is completed to your satisfaction.
Note that your invoice is required in the event that
you wish make a guarantee claim.
IMPORTANT INFORMATION FOR THE INSTALLER.
This appliance may only be installed by a gas in-
staller registered with the South African qualification
and certification committee (SAQCC). The appliance
must be installed in accordance with the
requirements of SANS 10087-1for use with LPG,
SANS 827 for use with NG and any fire department
regulations and/or local bylaws applicable to the
area. If in doubt, check with the relevant authority
before undertaking the installation. Upon completion
of the installation you are required to fully
explain and demonstrate to the user the operational
details and safety practices applicable to the
appliance and the installation.
Advertisement
