Subscribe to Our Youtube Channel
Summary of Contents for RVR Solar Closet 300 PS
- Page 1 Closet 300 PS Unit Water pressurisation unit Installation, Usage and Maintenance Instructions 20171206...
- Page 2 01. INTRODUCTION This document contains instructions for the use and maintenance of the Closet 300 PS unit. The Closet 300 PS has been designed to pump clean water not containing abrasive particles. Before installing and using the Closet 300 PS, read the following instructions carefully. RVR Energy Technology declines...
-
Page 3: Electrical Installation
04. ELECTRICAL INSTALLATION The Closet 300 PS is supplied with a 3 core mains cable with a length of 2 metres. A 220/240V 50Hz single phase supply with neutral and earth is required. All wiring must comply with l.E.E. and all local, national and EU requirements. THIS APPLIANCE MUST BE EARTHED. -
Page 4: Operating Instructions
05. OPERATING INSTRUCTIONS The controller has a green Power on light, a yellow Pump On light and a red Failure light. The green Power On light indicates that a voltage is connected to the control- ler. The yellow Pump On light indicates that the pump is running. When the power supply is turned on, both the green and yellow lights come on and the pump is started for a few seconds in order to allow the system to build up pressure.
Need help?
Do you have a question about the Closet 300 PS and is the answer not in the manual?
Questions and answers