Flamerite Fires Little Atom Quick Start Manual

1. Installation of Stove
WARNING: Please ensure the following are strictly adhered to upon installation.
A minimum clearance of 40mm is required around the top, both sides and to the rear of the stove. If not this may cause
the heater to cut out.
The Stove must be positioned so that the plug socket is accessible once installed. In the unlikely event of breakdown access
must be allowed to the rear of the Stove so that it may be serviced. The mains cable must therefore be long enough to
allow this. If the removal of the plug is absolutely necessary for installation, cut off within 100mm only of the plug itself.
Any further may affect your warranty.
Where the Stove is being used in an existing chimney, it is very important that the chimney and its drawn airflow are
completely blocked off to prevent directional airflow problems with the heater as well as the thermal cut out to activate.
Positioning the Stove.
Your Stove has primarily been designed for use as part of a fireplace suite although it may be used freestanding. Due to its weight
The Little Atom comes with its cast iron top and door packed separately so it may be better manoeuvred into position. If using in
conjunction with one of our Fireplace suites, a piece of glass is also supplied which should be placed on the hearth for the stove to
sit on.
(Optional) 150mm Fireplace Deeper Stove Insert
Before final fitting of the fireplace the Stove Insert must be attached to the mantle. We recommend this be done as close as
possible to the hole the fireplace is to be fitted.
Push the two together and screw the back panel to the mantle using the screws in the bag labelled red into the holes only
marked in red.
Secure the base with the screws in the bag labelled black into the holes only marked in black.
Next unscrew the connection box on the inside of the mantle leg (this should be left unscrewed) and connect the wires,
Live (brown) to Live (brown) and Neutral (blue) to Neutral (blue) from the stove insert. (12v)
Now gently push the fireplace into position.
Coal Fuel Effect Layout
The stove is supplied with two pieces of orange fuel bed, 1 flat, 1 U-Shaped, 8 orange coals, 6 small, 5 medium and 4 large ceramic
coals.
Place the flat orange fuel bed into the recess above the light bulbs, followed by the U-Shaped part onto and against the
back of the chamber, open area down. Fig.1
Next proceed with placing the 8 orange coals in any order into the chamber, 4 on top of the U-Shaped part and 4 in front
on the flat orange fuel bed. Fig.2
The 6 small ceramic coals, place in the chamber in front of the 4 most forward orange coals. Fig.3
The medium size ceramic coals, place all 5 across the middle of the fuel bed to the rear of the small ceramic coals, on top of
the front 4 orange coals. Fig.4
Continue laying the 4 remaining larger ceramic coals to the rear of the 5 ceramic coals just laid on top of the second set of
orange coals. Fig.5
The coal formation is subjective to the end user but we recommend the above steps to give the most authentic look. Please spend
time adjusting to suit.
Flamerite Little Atom Electric Stove
Page 1 of 4