Download Print this page

Nootools II Ballmagnet Nstallation Instructions

Advertisement

Quick Links

Congratulations on your new:
2 Net Arrays (3x panels per array)
Adjustment
Straps (2x)
READ IN CONJUNCTION WITH INSTALLATION VIDEO AT WWW.BALLMAGNET.COM
PRIOR TO INSTALLATION
• Do not unpack until ready to install
• Check contents
• No tools required
• We recommend 2 person installation
TWO PERSON INSTALLATION
(RECOMMENDED)
Remove from packaging.
1
Lay the spooled Ball Magnet close to
2
the tennis net on the center line.
• Ensure the end of the spool with the
white cord is closest to the tennis net.
NET
WHITE CORD
CENTER LINE
Unroll both spools keeping it taut to avoid
3
risk of tangles.
• Ensure netting does not slip off the spools.
UNROLL NEATLY
WHITE CORD
PARALLEL TO NET
Tethers (3x)
Cord Lock Tensioner (6x total, 3x per side)
4
Find the black cords attached to the posts
on one end. Extend them.
• On the other end, extend the black straps.
EXTEND BLACK
CORDS
5
Pick up the end posts, one in each hand,
stretch out the Ball Magnet and lift it over
the tennis net so poles are vertical.
• Check that the white cord is along the
bottom edge.
KEEP POSTS
SEPARATE
Separate the end posts so that each side of
6
the Ball Magnet can be lowered on to each
side of the tennis net.
LIFT OVER NET
AND DROP DOWN

INSTALLATION INSTRUCTIONS

PLEASE WATCH VIDEO:
www.ballmagnet.com
Center
Anchor Locks
White Line
EXTEND
ADJUSTABLE
STRAPS
PICK UP,
ROTATE 90˚
& STRETCH OUT
Positioning Knots (2x per tether)
Fixed
Cords (2x)
End Posts (4x)
FIRST Lower the end with the black cords
7
until posts are on the ground.
• Ensure the black cords are horizontal round
the tennis net pole and parallel.
• Check the end posts are
adjacent and vertical.
BLACK CORDS
INSTALLED
SHOULD BE
BLACK CORDS
HORIZONTAL
GO ON FIRST
Stretch the other end into position
8
and lower posts.
• Tighten the straps enough to
prevent sagging but DO NOT OVER
TIGHTEN STRAPS.
• The Ball Magnet should follow the natural
line of the tennis net.
• If balls bounce off the Ball Magnet,
it may be too tight.
ALL POSTS
SHOULD BE
VERTICAL
PULL ON ENDS
WITH STRAPS
TIGHTEN. DO NOT
OVER-TIGHTEN

Advertisement

loading

Summary of Contents for Nootools II Ballmagnet

  • Page 1: Installation Instructions

    Adjustment Straps (2x) Cord Lock Tensioner (6x total, 3x per side) White Line READ IN CONJUNCTION WITH INSTALLATION VIDEO AT WWW.BALLMAGNET.COM PRIOR TO INSTALLATION FIRST Lower the end with the black cords Find the black cords attached to the posts until posts are on the ground.
  • Page 2 4. Check that the Ball Magnet is at the same height on both sides of the Ball Magnet™, a Nootools II Company • Patent Pending, Copyright 2012, all rights reserved tennis net. Phone: 540-904-0887 • 55 St. John Place Suite 201 New Canaan, CT 06840 • Email: service@ballmagnet.com...