Nitrous Express 11107 Installation Instructions

Congratulations on purchasing the worlds' first and
finest remote bottle opener. This opener will allow you
to stay in the comfort of your seat and open your nitrous
bottle. Nitrous Express has designed the opener to work
with NX bottles, but may be adapted to fit all other bottles
valves.
The motor has been installed on the main body for
your convenience. The motor can be rotated to 4 different
positions if clearance is needed
1.
Remove the bottle from the vehicle, leaving the nut
and nipple intact. Install a cap onto the nipple to
prevent nitrous flow. Open the valve completely (Do
not over open the valve). This will give the proper
installation height for the opener to work without
binding. (See Illustration A)
2. Remove plastic cap on hand wheel. Using a ½
wrench remove the hand wheel from the top of the
bottle valve.
3. Install the adaptor collar around the top of the
bottle valve just below the hand wheel. (See
Illustration B.) Now tighten allen bolt on collar to
secure it to the valve.
4. Install the valve opener gear over the square brass
stem on the top of valve. (See Illustration B)
5. Install the nut from the original hand wheel onto
the opener gear. The opener gear now serves a
dual purpose, becoming a hand wheel when the
body is removed to assist in filling the nitrous
bottle.
6. Install the main body over valve and collar
making sure the gear on the drive motor meshes
with the bottle gear correctly and the hole for
the thumbscrew is properly aligned. NOTE: IF
THE GEARS DO NOT MESH CORRECTLY,
THE MAIN BODY WILL NOT SET DOWN
PROPERLY AND DAMAGE TO THE DRIVE
MOTOR TRANSMISSION IS POSSIBLE
7. Once the main body is installed correctly, tighten
the thumbscrew securely (HAND TIGHT!). (See
Illustration C)
8. Wiring your system. (See Illustration D) Cut the blue
and black wires 10 inches from the motor. Install
REMOTE BOTTLE OPENER
PN 11107
.