3M Unitek Ortholux Technique Manual

Ortholux Luminous Curing Light Technique Guide
™
Installation
1. Read instructions 2. Plug charger into wall outlet
Operation
1. If handpiece is in SLEEP 2. Use eye-shield and/or orange
mode, briefly press START glasses
button to wake up unit
Maintenance
LEDs showing
light intensity
Testing area
1. Measure light intensity by 2. Remove and inspect
placing light guide tip flat both ends of light guide
on testing area located on for cracks, chips, dried
charger base and activating adhesive, etc.
the light
3
3M Unitek
In U.S. and Puerto Rico: 1-800-423-4588 • 626-574-4000
Orthodontic Products
In Canada: 1-800-443-1661
2724 South Peck Road Technical Helpline: 1-800-265-1943 • 626-574-4577
Monrovia, CA 91016 USA CE Hotline: 1-800-852-1990 x4649 • 626-574-4649
www.3MUnitek.com Outside these areas, contact your local representative.
3. Attach the light guide
Eye-shield
TIME button
3. Press TIME button to select
exposure time
3. Clean both ends of light
guide with a soft cloth. Light
guide can be autoclaved
Please recycle. Printed in USA.
© 2009 3M. All rights reserved.
012-198 0904
4. Insert the eye-shield 5. Remove battery cap
and insert battery into
handpiece. Tighten by
turning clockwise
4. Briefly press and release 5. For Tack Cure, press and hold
START button to activate selected START button
exposure time
4. Clean charger, handpiece, 5. Wipe dry all parts
eye-shield by spraying before use
disinfectant on a towel and
wiping down
6. Charge unit for two hours
6. Rotate light guide independent of 7. Hold light guide 1-2 mm
eye-shield to achieve desired light above appliance,
guide position and eye protection perpendicular to tooth
during cure surface
6. To remove battery from
handpiece turn counter-clockwise