Page 6
ENGLISH 2 OVERVIEW COMPONENTS (FIG A) This manual is consistent with the date of manufacture of your machine, you will find information on the technical data of the machine acquired manual check for updates 1. Sheet or cutting line. of our machines on the website: www.grupostayer.com 2.Drive shaft assembly 3.
Page 7
ENGLISH - Dress properly. Do not wear loose clothing or jewellery. Use the cutting installation exclusively in Keep your hair, clothing and gloves away from the combination with the shrub knife. tool. Loose clothes, jewellery or long hair can become entangled in the moving parts.
Page 8
ENGLISH - In start-up or during operation of the engine, never - BLADE COASTS AFTER THROTTLE IS RELEASED - touch hot parts such as the muffler, the high voltage A coasting blade can injure you or bystanders. Before wire or the spark plug. servicing the blade, always turn off engine, and be sure - After the engine has stopped, the muffler is still hot.
Page 9
ENGLISH 8.5.2 Assembly spool (Fig. 4) A few practice swings without starting engine should be made to determine correct balance. NOTE: Detach - Install the flange washer and cup washer on the spindle the shoulder harness from the unit before starting shaft.
Page 10
ENGLISH 11 MAINTENANCE 10.5.3 Fence / foundation trimming Approach trimming around chain link fences, picket 11.1 Air filter fences, rock walls and foundations slowly to cut close without whipping string against the barrier. If the string CAUTION: NEVER operate trimmer without the air filter or comes in contact with rock, brick walls, or foundations, it dust and dirt will be sucked into the engine and damage it.
ENGLISH 16 TROUBLE SHOOTING = Shaft length. PROBLEM PROBABLE CAUSE CORRECTIVE ACTION Incorrect starting Follow instructions in the = Fuel tank capacity. procedures. User Manual. Incorrect carburettor Have carburettor adjusted = Weight. mixture adjustment by an Authorized Service Unit won’t start or setting.
- We also disclaim all liability for any bodily injury The undersigned: STAYER IBERICA, S.A. resulting from inappropriate use of the tool. - Repairs may only be carried out by an authorised With address at: customer service centre for STAYER.
Need help?
Do you have a question about the GAS CUTTER 33 and is the answer not in the manual?
Questions and answers