Page 1
AP791411 Ceres weather station WIRED TEMPERATURE STATION Instruction Manual INTRODUCTION: Congratulations on purchasing this Temperature Station with wired Weather Station which displays the time, date, indoor temperature and humidity, also outdoor temperature readings. It is further featuring an alert with indoor temperature &...
Page 2
The Temperature Station SETTING UP: 1. First, insert the batteries into the Temperature Station (see “How to install and replace batteries in the Temperature Station” below). Once the batteries are in place, all segments of the LCD will light up briefly and a short signal tone will...
sound. Then the indoor temperature, the time as 0:00 and the date as 1.1. will be displayed. If the indoor temperature is not displayed after a few seconds, remove the batteries and wait for at least 10 seconds before reinserting them. Once the indoor data is displayed proceed to step 2.
Page 4
Manual Time setting: Time setting When you hear a “BI” sound, you can start the setting as follows: Press and hold SET key for 3 seconds to enter time setting mode, the 12 hr flashing. Press UP/DOWN key to select 12hr/24hr mode. Press SET key again, the word is flashing.
Page 5
styles you can choose. Press SET key to confirm the setting and enter the snooze time setting. snooze time Times of snooze When you are in snooze mode, you can see the above display. If you want to set the snooze time then enter the snooze setting mode or do not touch any key for 30 seconds.
Page 6
remains display. Press any key to stop alarm, but “Z” mark remains flashing. How to turn on/off the alarm? 1) To turn off the alarm: At time mode, press MODE key to enter into the alarm mode. Press UP key to turn off the alarm the “...
Page 7
1) Press and hold SET key for 3 seconds to enter the alert setting, the “90℃” or “194℉” would start flashing. It’s the max temperature of outdoor. see the below display: Outdoor temperature alert setting: -50℃ to 90℃ or -58℉ to 194℉;...
Page 8
last 5 seconds, 55 seconds later it will be cycling alert until be stop by any key or the current value goes up or down to the setting then it would stop automatically. How to use the cable sensor: The cable is 1.8m long. Please release the cable first and place the sensor out of the window, then remove the shield of the sticker on the sensor.
Page 9
Icon 3 (cloudy): Icon 4 (rainy): Key function guide for Temperature Station key name Functions “MODE ” Use to enter the set mode for the following functions: time, alarm, alert display. Stop the alarm “SET” Press one time to change the display icon between ℃...
Page 10
temperature and humidity. Stop the alarm. “DOWN” Used to decrease the number when in setting mode. Press and hold it, alert will be on/off with the “ ” appear/disappear. Stop the alarm “SNZ” Used to turn on the snooze function when alarm on.
Page 11
Remark: Power supply : DC 3V; Accuracy : ±1℃, ±5% Temperature alert setting Max. temperature > Min. temperature with 1ºC resolution Humidity alert setting Max. humidity > Min. humidity with 1% resolution. When alert on, the signs of the temperature and alarm are flashing with 1HZ frequency all the time.