Do you have a question about the 699784 and is the answer not in the manual?
Questions and answers
Summary of Contents for Guide Gear 699784
Page 1
Congratulations on your Guide Gear™ purchase. Take your game to the next level with field-tested Guide Gear™ products for a confident, competitive edge that strikes the perfect balance between performance and value. 200W/800A Power Pack 699784 For assistance with your Guide Gear™ product, please contact the Sportsman’s Guide customer service at 1-800-888-5222 7am-7pm CST Mon-Fri or e-mail us custserv@sportsmansguide.com.
Intended Use The GUIDE GEAR 200W 800A Power Pack is easy to use and designed for years of reliable service. It can run many AC& DC appliances whenever you need power for work or play, at home or on the road.
Important Safety Information ⚠WARNING Read and understand all instructions. Failure to follow all instructions may result in serious injury or property damage. The warnings, cautions, and instructions in this manual cannot cover all possible conditions or situations that could occur. Exercise common sense and caution when using this power pack. Always be aware of the environment and ensure that the tool is used in a safe and responsible manner.
Do not allow the power pack to come into contact with an electrical source. The tool is not insulated and contact will cause electrical shock. Keep children and bystanders away from the work area while operating the tool. Do not allow children to handle the power pack.
Page 5
Do not expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of electric shock. Do not abuse the power cord. Never use the power cord to carry the tools or pull the plug from an outlet.
Disconnect the power source from the power pack, before attempting to clean or operate the power pack. Turning OFF the power pack does not reduce the risk of electric shock. Have a qualified technician perform any service work ...
Reference. Subassembly 12V DC ON/OFF switch Boosting cable (positive) Hose holding compartment Handle Boosting cable (negative) Reverse connection indicator (RED) Correct connection indicator (Green) Before Each Use ⚠WARNING 1. Charge unit fully prior to each use. 2. Follow all instructions published by the battery manufacturer and the manufacturer of the equipment in which the battery is installed.
5. Press the “inverter” ON/OFF switch button to turn off inverter after each use. 6. Recharge the power pack immediately after use. Refer to Recharging the Power Pack with AC Charger ⚠WARNING SPARK AND EXPLOSION HAZARD In case of using many AC appliances, use an AC power bar for additional AC outlets. However, for continuous operations the combined loads must be less than 200 W.
Page 9
Operating LED Work Light 1. Press the Light button to turn on the LED light 2. The LED light has multiple functions, (ON-SOS-Flash-OFF) , press light button to select the desired function. And turn off the LED light after use. Failure to do so may discharge the internal battery to dead.
14. Disconnect the positive (red)(+) clamp and then the negative(black) (–) clamp from the battery of the vehicle. 15. Store the clamps separately after use. 16. Recharge the booster pack immediately after use. ⚠WARNING Allow the power pack to cool down for at least 3 minutes after each boost. ...
Inflating Vehicle, Motorcycle, and Bicycle Tires 1. Check battery capacity status by pressing any button on the right of the LCD screen, to ensure that the battery is fully charged. 2. Uncoil the compressor hose from unit. 3. Ensure the locking lever of the valve connector is fully extended. 4.
condition of any booster pack be examined before it is used. Keep your booster pack in good repair. Keep handles dry, clean, and free from oil and grease. The following chart is based on a normal operation schedule. Maintenance Interval Maintenance Point Clean the exterior surface of the booster pack with a damp Before operating or after using...
Page 13
Failure Possible Cause Corrective Action The run time for The internal battery is Recharge the power pack by using appliance is less the AC charger until the unit is fully than expected. not fully charged. charged. The alarm sounds and reverse The jump start cables are Connect the jump start cables the connection indicator is on.
Need help?
Do you have a question about the 699784 and is the answer not in the manual?
Questions and answers