Advertisement
Installation Instructions
SAT
RF2 OUT
VCR/DVR
OUT 9
OUT 10
OUT 11
OUT 12
OUT 13
OUT 14
UHF
LDL216
16-way Distribution Amplifier
Frequency:
UHF 470-790MHz
FM/DAB 47-230MHz
Lte
800
Gain:
10dB
READY
Noise:
3.5dB
Return path:
5-15MHz with Insertion Loss 2dB
FM/DAB
DigiLink power:
9V DC on each outlet, 15mA
OUT 1
OUT 2
OUT 3
OUT 4
OUT 5
OUT 6
Or
Please Note: A UHF aerial can be connected
directly to the UHF input on the amplifier or
connected via a Satellite Receiver or VCR or
DVR if present.
No of Inputs
No of Outputs
Return Path Frequency Range
Return Path Gain
Frequency Range
UHF/FM/DAB Gain per port
Max Out put level (IMA3-60dB). EN50083-5
Noise Figure
Return Loss Input/Output
Isolation
All Ports IR Enabled
Built-in Power Supply
Dimensions
2
Digi Eye
MRX955
9th TV
RF In
Main TV
PSW122
Suitable for combined
TV and Radio outlet
OUT 15
OUT 16
TV
FM/DAB
Remote Rooms
PSW111
Suitable for TV outlet
OUT 7
OUT 8
Digi Eye MRX955
2nd TV
RF In
LDL216
LDL212
2
16
12
5-15MHz
-2dB
UHF: 470-790MHz FM/DAB: 47-230MHz
10dB
>108dBuv
<3.5dB
10dB/10dB
25dB
9V 15mA short circuit protected
220-240V~50Hz
340 x 120 x 55mm
Installation Instructions
Installation
Important note: attention is drawn to the General Safety Precautions Panel on page 4 which
contains advice on safe installation and operation of these products.
Location
Choose a location for the amplifier from which it is convenient to run cables from the
antennas and to the system outlets. Typical examples of suitable locations are a loft space or a
cupboard. In weak signal areas it is best to keep the antenna cables as short as possible.
Select a cool, dry location to install the amplifier. This means a location where the ambient
temperature will remain between -10°C and +40°C, and which is free from risk of dripping or
splashing water.
The fixing location should allow adequate access to the equipment for wiring and maintenance.
Clearance of at least 25mm should be allowed around the right hand side of the unit for
ventilation. More clearance will be needed on the other sides to allow access for cables.
Fixing
The amplifier should be fixed to a wall or other suitable hard surface, using suitable screws and
masonry plugs (not supplied). The amplifier should not be left supported by its own wiring, nor
should it be left resting on a carpet or other insulating and/or inflammable surfaces.
Electricity Supply
Fixed wiring and connection of the electrical supply to these products should be carried out in
accordance with BS7671 (IEE Wiring Regulations) .
Each amplifier is supplied with a fitted 13A mains plug. If this is not suitable, see General Safety
Precautions Panel on page 4.
As an alternative to the use of plug and socket connection, the amplifier may be connected to
the supply using a switched fused connection unit BS 1363-4. A 3 Amp fuse to BS1362 should be
fitted in the fused connection unit.
If the power unit is connected to the supply other than by means of its fitted fused plug or a
fused connection unit, It must be protected by a non-time delayed fuse or a type B MCB at the
distribution board of rating not exceeding 6A. An isolating switch should be provided near to
the unit to allow it to be disconnected from the supply when necessary.
Signal Connections
Input and output signal connections are made using f type (IEC 60169-24) connectors.
Good quality plugs should be used, preferably of the crimp on type. Attention is drawn to the
need to maintain DC continuity throughout the system for correct operation of infra-red remote
control functions.
Resetting RF Channel on a Digibox
1. Switch on your Sky™/Sky+™/ Sky+ HD™ receiver and view on your main television.
2. Press the SERVICES button on your Sky™ remote.
3. Select SYSTEM SETUP option (for SKY+ HD there is no SYSTEM SETUP option press 0 instead).
4. Press the following buttons in sequence: 0, 1, SELECT (for SKY+ HD this is a hidden option
and does not appear on screen). You should now see the installers' menu.
5. Select the RF CHannEL nUMbER option and key in a new channnel number from 21-58.
Make a note of the channel number you choose as you may need it when tuning your
other TVs.
3
Advertisement
