Advertisement
Link-It
™
INSTALLATION INSTRUCTIONS
SOFT SHACKLE ANATOMY:
Shackle Eye
SHACKLE CONFIGURATION
TWO-PASS
1
Set the bearing points close together, about one foot less than the desired shackle overall length.
2
Place the button knot between the two bearing points Avoid placing the base of the tail on the
bearing point if possible.
3
Thread the shackle eye end around
the other bearing point.
SamsonRope.com
Crossover Point
Rope Diameter
Bearing
Points
Shackle Body
Shackle OAL
Base of tail
4
For a 2-pass system, thread the shackle
eye through the first and second bearing
points again. Balance the length of each
shackle leg as much as possible (when
loaded, they will adjust even more so).
Buried Tails
Button Knot
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Samson LINK-IT
Summary of Contents for Samson LINK-IT
- Page 1 Link-It ™ INSTALLATION INSTRUCTIONS SOFT SHACKLE ANATOMY: Shackle Eye Shackle Body Buried Tails Crossover Point Button Knot Rope Diameter SHACKLE CONFIGURATION Shackle OAL TWO-PASS Set the bearing points close together, about one foot less than the desired shackle overall length.
- Page 2 FINISHED TWO-PASS INSTALLATION. As the shackle is loaded the legs will adjust and balance. CORPORATE HEADQUARTERS 2090 Thornton Street, Ferndale, Washington 98248 USA +1.360.384.4669 +1.360.384.0572 SamsonRope.com Link-It™ is a trademark of Samson Rope Technologies, Inc. © 2019 Samson Rope Technologies, Inc. All rights reserved. 1/2019 2179...
Need help?
Do you have a question about the LINK-IT and is the answer not in the manual?
Questions and answers