Lynteck TITAN TF20WLED Quick Start Manual

TITAN
10W x 2 LED FLOODLIGHT
•
‚
• LED lamp heads
‚ Wall mount / terminal block
ƒ PIR detector
INTRODUCTION
The Titan twin head 20W LED Floodlight offers you an
economical lighting solution with extremely low energy
consumption.
During darkness, the built-in passive infrared (PIR)
sensor turns on the Floodlight when the PIR sensor
detects a moving heat source in its coverage area. During
daylight, the built-in photocell sensor saves energy by
deactivating the Floodlight.
Note: Please read this entire manual before you start
installation.
SAFETY PRECAUTIONS
l DO NOT install when it is raining.
l Isolate the power supply before installation.
UK Building Regulations require outdoor mains
l
installations be carried out by a qualified electrician.
l BS7671: 2008 IEE Wiring Regulations must be
complied with in all respects.
l HO5RNF round flexible cable and drip loops must be
used to avoid water ingress damage to the unit.
l Ensure that the power supply is protected by a 6A
circuit breaker or suitable fuse.
l Ensure minimum distance of 0.5m away from lighted
objects.
l The unit must be installed vertically (FIGURE 1a)
NOT horizontally (FIGURE 1b).
VERTICAL
FIGURE 1a
•
ƒ
HORIZONTAL
FIGURE 1b
CHOOSING A MOUNTING LOCATION
l For the best results, mount the Floodlight onto
normal brickwork 2.5m above the ground.
l Avoid aiming the PIR sensor at pools, heating vents,
air conditioners or objects that may change
temperature.
l Avoid pointing the PIR sensor at trees or shrubs or
where the movement of pets or animals may be
detected.
Avoid locations where direct sunlight will shine onto
l
the front of the PIR sensor for long periods,
deterioration of the Fresnel lens may occur leading
to poor triggering response.
l Prior to mounting, keep in mind that the PIR sensor
is more sensitive to a heat source moving across its
coverage area and less sensitive to a heat source
that moves directly towards the PIR sensor
(FIGURE 2).
Select a location for the unit based on the coverage
angles shown in FIGURE 3.
180¢X 180°
COVERAGE ANGLES
2.5m
FIGURE 2
110°
110¢X
FIGURE 3