Qazqa Suspense WL Dark Grey Instruction Manual

INSTRUCTION MANUAL
Suspense WL Dark Grey
92304
1
2X
PWA3X35MM
OFF
2X
Ф6x30mm
OFF
1
6
7 8
Unchangeable LED
Max.40x0.5W LED
3000K±300K
10000H
10 11
220 - 240V
~50HZ
188mm
210mm
IP44
G U A R A N T E E
2 Y E A R S
2 3
5 6
9
Brown(Power Cable)
Yellow/Green(Power Cable )
Blue(Power Cable)
12
PIR Control Knob
ON
ON
Wall Mounting Screws
Rubber Mat
Wall Mounting Cover
Lamp Body
Φ6 Plastic plugs
Rubber plug
Power Cable
Cover Screws
Anchorage
Terminal Block
INSTRUCTION MANUAL
Suspense WL Dark Grey
92304
INTRODUCTION
█
The PIR (Passive Infra Red) SENSOR has a sensing device which continuously scans a
preset operating zone and immediately switches the lamp on when it detects movement in
that area. This means that whenever movement is detected within the range of the sensor
the lamp will switch on automatically to illuminate pathways, steps, patios, porches, or
whatever area you have selected to light for reasons of safety, convenience or security.
While there is movement within range of the unit the lamp will remain on.
HOW TO FIT THE UNIT
█
To achieve best results, we suggest you take into account the following points:
■ Ideally the PIR SENSOR should be mounted 1.8 to 2.5 meters (6 to 8ft) above the
area to be scanned (Refer to Fig.1A).
■ To avoid damage to unit-do not aim the sensor towards the sun.
■ To avoid nuisance triggering, the sensor should be directed away from heat sources such
as barbecues, Air-conditioners, other outside lighting, moving cars and ue vents.
■ To avoid nuisance triggering, keeping away from the area of strong electromagnetic
disturbance.
■ Do not aim towards re ective surfaces such as smooth white walls, swimming pools, etc.
The PIR Sensor scanning speci cations (the distance and angle it covers approx. 12 meters
and 180°--- at 20℃ and dry weather) may vary slightly depending on the mounting height
and location. The detection range of the unit may also alter with temperature change. Before
selecting a place to install your lamp(s), you should note that movement across the scan area
is more effective than movement directly toward or away from the sensor. (Refer to Fig.1B).
If movement is made walking directly towards or away from the sensor and not across, the
apparent detection range will be substantially reduced. (refer Fig. 1C)
INSTALLATION
█
Installation the Floodlight, please referring to the Figure
1. Installation by a licensed electrician and according to IEC wiring Regulation.
2. Switch power off at the meter box and ensure that there is no power to the light.
3. Unscrew the Cover screw