BARRON Trace-Lite LP22-SMK Installation Instructions

Surface mount kit

Advertisement

LP22-SMK, LP24-SMK, LP14-SMK
Surface Mount Kit Installation Instructions
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
When using electrical equipment, basic safety precautions should always be followed including the following:
• DISCONNECT AC POWER SUPPLY BEFORE SERVICING.
• Installation and servicing of this equipment should be performed by qualified service personnel only.
• Ensure that the electrical wiring conforms to the National Electrical Code NEC® and local regulations
if applicable.
• Do not mount near gas or electrical heaters.
• Equipment should be mounted in locations and at heights where it will not be readily subjected to tampering
by unauthorized personnel.
• The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
• Any modification or use of non-original components will void the warranty and product liability.
• Do not use this equipment for other than intended use.
20070146 REV 1 - 11/19

IMPORTANT SAFEGUARDS

SAVE THESE INSTRUCTIONS!
Technical Support
■ (623) 580-8943 ■ technicalsupport@barronltg.com
1
800-533-3948 www.barronltg.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Trace-Lite LP22-SMK and is the answer not in the manual?

Questions and answers

Summary of Contents for BARRON Trace-Lite LP22-SMK

  • Page 1: Important Safeguards

    LP22-SMK, LP24-SMK, LP14-SMK Surface Mount Kit Installation Instructions IMPORTANT SAFEGUARDS READ AND FOLLOW ALL SAFETY INSTRUCTIONS. When using electrical equipment, basic safety precautions should always be followed including the following: • DISCONNECT AC POWER SUPPLY BEFORE SERVICING. • Installation and servicing of this equipment should be performed by qualified service personnel only. •...
  • Page 2 LP22-SMK, LP24-SMK, LP14-SMK Surface Mount Kit Installation Instructions 1. Locate the area where light panel will be installed Fig. 3. 2. Assemble (4) sides of surface mount kit, insert (8) small screws into corresponding holes and tighten Fig. 1. 3. Check squareness of assembled surface mount kit frame and trial insert light panel from back to check fit. Remove light panel.

This manual is also suitable for:

Trace-lite lp24-smkTrace-lite lp14-smk

Table of Contents