Advertisement
fig 1
4.
OPERATING INSTRUCTIONS
4.1
OPERATING
WARNING! Ensure you read, understand and apply safety instructions.
4.1.1 Connect the die grinder to the air supply.
4.1.2 To start, hold firmly and twist the gripped section ("ON" and "OFF" are marked on the body).
4.1.3 The bit must be running at its maximum speed before attempting to grind the workpiece.
4.1.4 Slowly and smoothly bring the grinding stone toward the workpiece (avoid jerky
movements).
Avoid subjecting stone to excessive strain or harsh impacts.
Always hold die grinder firmly and ease grinding stone against workpiece. Maintain a
controlled progression.
4.2
CHANGING GRINDING STONES
WARNING! Disconnect from the air supply before changing grinding stone.
4.2.1 Check that grinding stones are not damaged in any way such as cracks, deformations
or splinters etc. Damaged stones must not be used.
4.2.2 Use wrenches provided to loosen collet locking collar. Insert grinding bit and re-lock collar.
DO NOT allow die grinder to free run for an extended period of time as this will shorten
bearing life.
5.
MAINTENANCE
WARNING! Disconnect die grinder from air supply before changing accessories, servicing
or performing maintenance. replace or repair damaged parts. Use genuine parts only.
Unauthorised parts may be dangerous and will invalidate the warranty.
5.1
If air supply does not have an oiler, lubricate the air tool daily with a few drops of Sealey air
tool oil dripped into the air inlet to prolong its life.
5.2
Clean the die grinder after use.
5.3
loss of power or erratic action may be due to the following:
a) Excessive drain on the air line. Moisture or restriction in the air pipe. Incorrect size or
type of hose connectors. To remedy check the air supply and follow instructions in
chapter 3.
b) Grit or gum deposits in the die grinder may also reduce performance. If your model has
an air strainer (located in the area of the air inlet), remove the strainer and clean it.
Flush the die grinder out with gum solvent oil or an equal mixture of SAE No 10 oil and
paraffin. Allow to dry before use.
5.4
For a full service contact your local Sealey service agent.
5.5
When not in use, disconnect from air supply, clean die grinder and store in a safe, dry,
childproof location.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7Ar
Original Language Version
fig 2
www.sealey.co.uk
01284 757500
Web
sales@sealey.co.uk
01284 703534
email
SA673
Issue: 2 - 12/11/09
Advertisement
