Advertisement

USER
MANUAL

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Stylophone Gen R-8 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Dubreq Stylophone Gen R-8

  • Page 1 USER MANUAL...
  • Page 2: Table Of Contents

    CONTENTS IMPORTANT PLEASE READ THIS INSTRUCTION MANUAL BEFORE USE AND KEEP FOR FUTURE REFERENCE WARNING OVERVIEW • Keep these instructions for the unit will invalidate the reference as they contain warranty. If operating the unit with important safety and • If the appliance malfunctions, KEYBOARD headphones, earbuds or operating information.
  • Page 3: Overview

    OVERVIEW KEYBOARD QUICK The Stylophone GEN R-8 is a dual VCO British made START boutique synthesizer with a fully analog signal path. The Stylophone GEN R-8’s analog oscillators need to Both VCOs have “divide-down analog” sub-oscillators (one warm up for a few minutes octave down) and subsub oscillators (two octaves down) after you’ve switched it on.
  • Page 4: Control

    CONTROL OSCILLATORS GLIDE CONSTANT OSC1 WAVE The CONTROL section on The OSCILLATOR section the front panel is for setting is where you select This button determines which parameter is held constant Oscillator 1 has two basic waveforms, sawtooth and square. the behaviour of the MOD waveforms and tune the when performing a glide using the GLIDE key on the keyboard.
  • Page 5: Lfo

    OSCILLATOR CALIBRATION CV PATCH POINTS FOR DESTINATION ONE SHOT THE OSCILLATORS Press and hold the RING MOD and OSC SYNC These buttons route the LFO to the most common This button resets the LFO keys simultaneously for a few seconds. The destinations.
  • Page 6: Envelope

    RESONANCE ENV DEPTH CV PATCH POINTS FOR THE ENVELOPE RELEASE This knob determines the amount of filter emphasis around Use this knob to set the GATE IN CV input for a gate signal to trigger the envelope This knob sets the last time and holding it open in the Sustain stage until the cutoff frequency.
  • Page 7: Mixer

    MIXER SEQUENCER VOLUME The step sequencer is used RECORD The mixer section adds to play a repeated sequence together the different This knob sets the level of the direct sound from the This button activates the Record mode and becomes lit of programmed notes on audio sources within the analog synthesizer engine.
  • Page 8: Drive

    MIDI PROGRAMMING SEQUENCE TRANSPOSE AND RESET PATTERN The sequencer is a powerful performance tool with which you This knob selects which of the MIDI CHANNEL PROGRAMMING can improvise sequence variations while it’s playing in time. 8 pattern memories that is DIP switch 4 engages the MIDI Channel Programming mode.
  • Page 9: Battery Information

    Reorient or relocate the receiving antenna. For all enquiries: info@dubreq.com Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
  • Page 10: User Notes

    USER NOTES ORIGINAL POCKET SYNTHESIZER PORTABLE ANALOG SYNTHESIZER...

Table of Contents