Advertisement
cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
the receiver.
• Connect the equipment to an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
3. Package Contents
• (1) Blu<>Hub adapter/control terminal.
• (1) Connection harnesses for the 2018-2019 Honda
Gold Wing. (NOT for airbag models)
4. Installation Instructions
1. Install VIDEO at
https://www.jmcorp.com/ProductDetail.
asp?ProductID=CBLU-GL1833
2. Remove the left side cover, right side cover and seat.
3. Open the center console door and locate the large
rubber grommet that contains the USB thumb drive
cable.
4. Pull this grommet out of its mounting hole and carefully
cut a slot from the side with a small pair of dykes.
5. Uncoil the included section of steel wire and push one
end thru the grommet hole inside the glove box, down
thru to the location under the seat.
6. Wrap the end of the wire around the large female 8-pin
din plug from the main harness and the pull this end
carefully up into the center console, thru the grommet
hole.
7.
Slide this new cable thru the slot in the grommet, then
reinsert grommet as you leave about 5" of the new
cable inside the center console.
8. Plug in the power supply box into the cable harness
under the seat, connect the orange wire to the acc
terminal + on the fuse block, the red wire with in-line
fuse direct to the positive (+) terminal of the battery and
the black wire to the frame ground bolt just above the
battery.
9. Secure the power supply box to an out of the way
location under the seat with double-back tape already
affixed.
Thank you for the confidence you have shown by purchasing one of J&M's inno-
vative products. If you have any questions during the installation, or require
further assistance, you may call us at USA 1-520-624-7000
Monday thru Friday 8:00 AM to 5:00 PM Mountain Standard Time,
10. Route both driver & passenger headset female plugs to
a location so that they will both protrude from under the
left side of the seat once reinstalled.
11. Secure all cables and wires with tie straps provided.
12. Plug the BluHub control terminal into the harness inside
the center console, plug in one or two helmet headsets,
turn the ignition to the ON or ACC position, rotate the
intercom volume knob clockwise about half way and
verify the driver/passenger intercom speech function.
13. Now reinstall both left & right side covers along with the
seat.
5. General Operation Instructions
1. Turn the ignition to the ON or ACC position.
2. Put the BluHub into pairing mode by first holding
down on the multifunction button for approximately
10 seconds until the unit turns off, and then release.
3. Then press and hold the multifunction button again
cycling thru the slow flashing blue, to flashing red and
blue, and then release as the BluHub is now in pairing
mode.
4. Then for the Honda system menu options go to Audio
Setting, then Bluetooth setting, then rider headset
pairing, then inquiry, then press abort when you see the
JM_CBLU_1833 appear at the bottom of the screen,
then press JM_CBLU_1833, and press OK as device
is successfully paired, then return to the main audio
system screen.
5. Once linked the first time, the BluHub will automatically
link back to the audio system each time the ignition
is turned on or to the accessory position, without any
additional input from the rider or passenger.
6. Now slide the BluHub back down into the storage
compartment, hop on the new Wing, plug in your helmet
headsets, adjust the intercom volume to a comfortable
level and you are ready to go.
7.
All system volume adjustments will now be made using
the normal handlebar mounted controls for the corded
headsets.
Supported Bluetooth Profiles:
• A2DP (Advanced Audio Distribution Profile)
• HFP (Hands Free Profile)
114 S. Cherry Avenue
Tucson, Arizona U.S.A.
Tel: (800) 358-0881
www.jmcorp.com
E-mail: audio@jmcorp.com
Advertisement
