Table of Contents
Advertisement
3-3
3-3-1 Operation Mode Setup and Adjustment
The setup switches (dip-switches) are located in the rear of the FP.
Prior to shipment, the FP's DIP switches (collectively called SW1) have been
set as shown above. These 8 DIP switches control the items listed below:
No.
Touch Panel Output Method
1
Backlight Setting 1
2
Backlight Setting 2
3
Backlight Setting 3
4
Calibration
5
Click Sound
6
Reserved
7
Reserved
8
• SW1-1
Designates the touch panel data output method.
! ! ! ! !
Important
3-8
Setup of Operation Mode and Positioning of Display
FP-775S (rear view)
Function
OFF: SIO (RS-232C) output
When the FP is connected to the host (PC), emulation software
(e.g TT-WIN) is required to perform touch operation.
ON:
PS/2 mouse compatible output
Touch panel data is converted to PS/2 mouse-compatible format,
and output through the mouse output port.
When the FP is connected to the Host's PS/2 mouse port, you can
perform touch operation without using special emulation software
or a special driver.
• The use of PS/2 mouse compatible output may be limited, depending
on the OS being used.
Reference
4-2 Touch Panel Data Input
Installation and Wiring
DIP-switch (SW-1)
OFF
RS-232C output
PS/2 mouse compatible
output
See table on next page
Normal mode
Calibration mode
Click sound OFF
Click sound ON
Set this switch to OFF
Set this switch to OFF
FP-775S User's Manual
ON
Advertisement
Table of Contents
