QNN Safe GTX Series User Manual page 2

QNN SAFE AUSTRALIA PTY LTD
Unit 9 / 376 Newbridge Road, Moorebank NSW 2170
Opening instructions:
 Prepare the Master Key into the position
 Press ○ * and then the code, and then press ○ # . The "OPEN" displayed with one
beep. The door is now ready for open. ( factory setting code "123456")
 Turn Master Key clockwise and turn the knob clockwise, safe now is unlocked.
( For some model, just turn the master key to open the door)
 Displayed "E-CODE" with 3 beeps means it is a wrong code try. 3 continual
wrong code tries will lead the loudly sound alarm activated for 60 seconds
 To deactivate the alarm, please follow the above instructions to enter the right
code.
 Any unexpected sharking and moving toward the safe body will lead the loudly
sound alarm be activated for 60 seconds
Closing instructions:
 Close the door
 Turn the knob counterclockwise (For some larger models)
 Turn Master Key counterclockwise, and remove the key.
Changing Code:
Please keep the door at open position during the whole processing until fully ensure
that the code is changed correctly.
For security reasons, please change to your own code after the first opening. Your
code can be set up to 10 digits
 Open the safe door
 Press the reset button which is located behind the door plate, near the upper hinge,
"USER" then displayed at LED window,
 Input your new own digital code (within 10 digits ), then press ○ #
 "AGAIN" then displayed at LED window
 To confirm, Input your new own digital code again, then press ○ #
 "DONE" then displayed at LED window with two beeps, which indicate that the
code is changed successful
 Keep the door open, check and remember the code.
ABN 47 168 078 233
Web site:
www.qnnsafe.com.au
Email:
info@qnnsafe.com.au
Phone: 02-87982669
Page 2 of 3