York Survey Supply 33065 Operating Instructions

Troubleshooting / FAQ
There is no outdoor temperature shown on the unit
Press the RE-SYNC button on the main unit and the outdoor
temperature will show within minutes. If no temperature is
shown within 6 minutes of the RE-SYNC button being
pressed, the remote unit is either too far away or there is
some interference between the remote and main unit. Bring
the remote unit to the main unit and re-synchronize. Then
move the remote unit to a new location closer and in direct
line with the main unit.
The remote temperature is reading 40.5°C when the
temperature is 15.5°C
The remote unit is in direct sunlight. Move it to a shaded,
protected area.
Care of Your Clock
• Avoid exposing your clock to extreme temperatures, water
or severe shock.
• Avoid contact with any corrosive materials such as perfume,
alcohol or cleaning agents.
• Do not subject the clock to excessive force, shock, dust,
temperature or humidity. Any of these conditions may
shorten the life of the clock.
• Do not tamper with any of the internal components of this
clock. This will invalidate the warranty and may cause
damage.
Correct Usage of the Batteries
• Use 2x AA batteries and 2x AAA batteries.
• Do not mix standard and rechargeable batteries.
• Do not mix new and old batteries.
• When the low battery icon appears on the display,
replace all batteries with new ones. When the low battery
icon appears on the REMOTE temperature field,
replace all batteries with new ones.
Specification
Temperature Measuring Range
Receiver: -50°C ~ +70°C with 0.1°C resolution
-58°F ~ +158°F with 0.2°F resolution
Transmitter: -50°C ~ +70°C with 0.1°C resolution
-58°F ~ +158°F with 0.2°F resolution
Temperature Checking Interval:
Receiver: every 16 seconds
Transmitter: every 16 seconds
Transmission Distance: maximum 100 feet in open field,
depending upon surrounding structures, mounting location
and possible interfering sources.
Power Source (alkaline batteries recommended):
Receiver: 2x AAA 1.5V batteries
Follow us!
Prospect House, George Cayley Drive, Clifton Moor, York, England YO30 4XE
York Survey Supply Centre
@York_Survey
E-Mail: sales@yorksurvey.co.uk
@York_Survey
Ref:.. \operat98\instructions 19\33065.qxp 17-01-19
Transmitter: 2x AA 1.5V batteries
Battery Life: about 12 months
Dimensions (L x W x H)
Receiver: 110 x 21 x 65mm
Transmitter: 100 x 30 x 70mm
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This
device must accept any interference received, including
interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void
the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and the
receiver
• Connect the equipment into an outlet or a circuit different
from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician
for help
Tel: +44 (0) 1904 692723 Fax: +44 (0) 1904 690385
www.yorksurvey.co.uk
Indoor/Outdoor
Thermo Hygrometer
Code: 33065
Operating
Instructions
©York Survey Supply Centre 2019