Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Sinn Manuals
  4. Sander
  5. DUOFLEX
  6. Assembly instruction manual

Sinn DUOFLEX Assembly Instruction Manual

The diving strap system
Hide thumbs
1
2
3
4
5
6
7

Advertisement

Quick Links

Download this manual
AS SE MB LY I NSTR U C T IO N FOR
T HE D I V I N G STR AP SYST E M

Advertisement

loading
Need help?

Need help?

Do you have a question about the DUOFLEX and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Sinn DUOFLEX

  • Page 1 AS SE MB LY I NSTR U C T IO N FOR T HE D I V I N G STR AP SYST E M...

  • Page 2: Content Of The Kit

    The kit also includes a practical storage pouch in which you can store your replacement strap and other accessories. The black pouch provides safe We explain below the individual steps for the fitting and using DuoFlex. Please first protection from spray water, dirt and sand. The pouch is fitted with a rolling read this introduction fully before carrying out the individual steps.
  • Page 3 Please note: On both adapters, the spring bars for fitting or removing the silicone strap (see Step 2) are pre-installed. These spring bars were developed specifically for DuoFlex and cannot be replaced by other spring bars. Long side Short side...
  • Page 4 STEP 3: Next, on the silicone strap half without the SINN logo, remove the metal pin at FITTING THE FOLDING CLASP WITH STRAP-LENGTH QUICK ADJUSTMENT position 2 and replace it by stud (see diagram). Slide the stud as centrally We recommend that you fit the folding clasp before shortening the silicone strap.
  • Page 5 Standard position STRAP-LENGTH QUICK ADJUSTMENT strap can be moved one position First, try on the fully fitted DuoFlex on your wrist before carrying out a quick forward or back. To make the silicone adjustment to the strap length. strap tighter, move it one position to the left.
  • Page 6 (e.g. due to temperature-related variations). To use a minimum margin, at least four positions should always be occupied on the silicone strap half without the SINN logo, in the following sequence: Metal pin , stud and two additional metal pins...
  • Page 7 Standard position the SINN logo. To do this, sever the silicone silicone strap half with the SINN logo. To do this, you will first need to remove the strap with a knife or pair of scissors centrally folding clasp. After doing this, sever the silicone strap again with a knife or pair between the last metal pin and the stud in of scissors –...