Advertisement
Color Light Stream™ Lighted Bubbler Kit Gunite
The Color Light Stream Lighted Bubbler is a very simple device to provide lighted water for
small fountains and sun shelf areas. The Color Light Stream Lighted bubbler is preassembled for
easy connection to a water supply line and a conduit connection for the fiber. The fiber is
already connected to the bubbler and comes with 25 feet of pre-attached fiber that will snap into
the LED driver. No fiber cutting!
IMPORTANT:
Read and follow all safety and installation instructions carefully. Read instructions
completely before start of installation!
The conduit for the fiber optic cable should be run to the Color Light Stream Mini Deck Box,
no more then 20' from bubbler
The Color Light Stream™ Mini Deck Box (LSMDB) is your distribution center to the wonderful
world of LED lighted water features. Designed as the connection center for all of SR Smith LED
fiber optic water feature products, simply place in the ground, per instructions and hook up the
fiber from the selection of our fiber products and enjoy the wonderful lighting effects from SR
Smith Color Light Streams products.
COLOR LIGHT STREAM DECK BOX IS MADE OF ABS MATERIAL. USE ONLY
ABS-PVC GLUE WHEN MAKING ANY PLUMBING CONNECTIONS TO THIS DECK
You now are set to start enjoying the wonderful lit Color Light Streams Water Features
manufactured by SR Smith
For additional product or installation help, please contact SR Smith Technical Service
department.
Input Power:
12V AC
Total Power:
5 W
ETL listed for installations within 5 ft. (1.5M) of outer edge of water
79-15159-00 REV B2 9.14
2CLSLBK
(75 strands of Fiber per Bubbler)
SAVE THESE INSTRUCTIONS!
BOX.
.
www.srsmith.com
4008814
Page 1 of 6
Advertisement
Table of Contents
Related Manuals for S.R.Smith Color Light Stream 2CLSLBK
Summary of Contents for S.R.Smith Color Light Stream 2CLSLBK
- Page 1 Color Light Stream™ Lighted Bubbler Kit Gunite 2CLSLBK (75 strands of Fiber per Bubbler) SAVE THESE INSTRUCTIONS! The Color Light Stream Lighted Bubbler is a very simple device to provide lighted water for small fountains and sun shelf areas. The Color Light Stream Lighted bubbler is preassembled for easy connection to a water supply line and a conduit connection for the fiber.
- Page 2 Installation Directions 1. The Color Light Stream Lighted Bubbler is designed to be installed during the gunite phase of the pool building 2. Two conduits should be run to the bubbler: a. 2 – 1 ½” PVC pipe for water supply. b.
- Page 3 9. Glue into place all conduit pipes at this time. It is recommended that all fiber optic conduits be no less then ¾” in diameter and that the 12VAC conduit for the wire on the Color Light Stream LED driver be no less then ¾”. It is highly suggested that you install all fiber conduit with sweep fittings for easy fiber installation.
- Page 4 Hold the ferrules together to create a square shaped bundle. While holding the ferrules together, insert into the strain relief opening as illustrated. Gently push all the ferrules until it is completely inside the strain relief and cannot not be pushed any farther.
- Page 5 Advanced control requires iStar Controller - see operation manual for further instructions When connected to an approved, 12VAC, Class 2 power supply - The S.R. Smith CLS-2 LED color changing light source uses simple ‘off / on’ power switching to control the basic, pre-defined color modes with memory function.
- Page 6 IMPORTANT NOTICE Note: DO NOT INSTALL THE BUBBLER TIP MORE THAN 4 INCHES ABOVE THE GUNITE SURFACE AREA. THE INTERIOR OPTIC ROD IS 4 ¾” DOWN FROM THE TIP’S TOP AND WILL BE DAMAGED IF TRIMMED FOR FLUSH INSTALLATIONS BELOW THIS LEVEL. The Color Light Stream™...
Need help?
Do you have a question about the Color Light Stream 2CLSLBK and is the answer not in the manual?
Questions and answers