Advertisement
Quick Links
Advertisement
Related Manuals for Stagnoli DAPHNE 6
Summary of Contents for Stagnoli DAPHNE 6
- Page 1 Istruzioni Instructions GB – Barrier DAPHNE 6...
- Page 2 It is forbidden to use it for any other purposes or improperly. • Use original components only. Stagnoli is not liable for damages if any other components • are used. Make absolutely certain the power is disconnected before carrying out any work on the •...
- Page 3 Istruzioni Instructions...
- Page 4 Istruzioni Instructions DAPHNE’S Technical Details Tecnical Details DAPHNE 6 Power Supply 230V~ (50Hz) Current absorbed Motor (A) Motor Power Supply 24V ––––– Maximum Power Max 120W Opening Time (sec) Operating Temperature (°C) -20 ↔ +60 Duty Cycle (%) IP Protection Weight* (Kg) Max.
-
Page 5: Manual Manoeuvre
Istruzioni Instructions Manual Manoeuvre The manual manoeuvring of the arm should • only be carried out when the motor has stopped due to a cut in the power supply Pull off the self releasing cylinder (1) and with • the Alan key (2) unblock the motor turning the key in an anticlockwise direction. - Page 6 Istruzioni Instructions Fixing the barrier Take the top cover off by unscrewing the screws (Fig. 3). • Open the barrier wings, position the barrier on the foundation plate making sure that the • lower holes correspond to the screwable rods and screw everything in place with the M10 nuts.
- Page 7 Istruzioni Instructions Adjusting the arm: the standard opening of the barrier is in an anticlockwise direction as in (Fig. 7). Fig. 7 To invert the opening direction of the arm, move the spring to the opposite position (Fig.8) • and invert the connection of the electric motor to the control panel (Fig.9). APM1 24V 120W CHM1...
- Page 8 Istruzioni Instructions Balance the barrier’s arm adjusting the screwable rods. The arm must be in equilibrium in • the half way position (45°) (Fig. 10). 45° Fig. 10 Proceed with the programming of the control panel following the specific electrical •...
- Page 9 Istruzioni Instructions Adjusting the chain’s tension The chain’s tension is adjusted directly in the warehouse, however, if you notice that the chain is slightly slack, adjust, using screws (1) as in example (Fig. 12). Tightening Slackening Fig. 12 Ordinary Maintenance It is advisable, after installation, to carry out checks on the moving parts, at least every 6 months: Check the balance of the arm ( if necessary rebalance the arm adjusting the screwable •...
- Page 10 Istruzioni Instructions Connecting integrated lamps : Open the top cover, unscrew the two lampholders and connect them as per the following diagram: F1 (T10A, 250V) POWER -BAT +BAT APM1 24V 120W CHM1 LAMP LAMP DISPLAY F3 (T3.15A, 250V) + ENC - ENC SIG.
- Page 11 Istruzioni Instructions...
Need help?
Do you have a question about the DAPHNE 6 and is the answer not in the manual?
Questions and answers