Advertisement
USER MANUAL
1. Put container from the storage position to the work position. Pull the slider out of cleaver.
Open the large and small plate as shown below
2. Set the cladding side of a striped and cleaned fiber into the corresponding fiber holder and
put it into the future slot NOTE: The striped side of fiber should be fixed in the V-groove.
Close the small plate and large plate orderly. Push slider to the other side to cut the fiber off
3. Open the large plate and small plate ordery, and take fiber out. Do not touch anywhere
NORMALE USE AND MAINTENANCE
• Must ensure that the rubber presser foot and the fiber guide groove
are clean (no dust and fiber debris). Keep the fiber contact surfaces
clean by using alcohol cotton or cloth during the process of cleaving
• Change the angle of blade. If cleaving quality drops ( usually cleave
1000 to 1500 times), the blade my be worn. Please follow the step
to adjust the blade angle.
A. Loosen the compression screw of blade
B. Rotate blade to the next scale number (generally there are 16 or 24
two types of blade)
C. Hold the side-face of blade and relock the screw to complete
adjustment
Adjust the height of blade
A. Please unscrew two screws as picture
B. Use hexagonal spanner to loosen
C. Adjust bolt as picture to adjust height of blade
6
Replace the blade
When the blade circulation is used, and you cannot improve the
cleaving quality by changing the angle of blade and adjusting the
height of stud, the bald needs to be replaces
A. Remove the screw and gasket of blade
B. Turn blade to the tool holder side, then hold side faces of
blade and take it out
C. Replace the used blade by a new one and then screw the
gasket and screw on. NOTE: DO NOT let the blade to collide
anything!
TROUBLE REMOVAL
Cleaver common failures:
The phenomenon of failures
Fiber cannot be cut through
Compressions Screw
The end face has fillet
The end face has fillet
Core missing
Height Fixing Screw
• According to the method above to adjust the cleaver, if there still have problems about
cleaving quality, please contact our service department
• If the slider does not move smoothly, rubber presser foot cannot close tightly and
striker device has obstruction problems, please contact the service department
Heigth Adjustment Screw
Pressure Screw
The failure Cause and Solution
1. Clean rubber presser foot,
2. elevate the height of blade
1. Elevate the height of blade,
2. If the rubber foot abrasive wear or
aging please replace them
Adjust the height of blade
Lower the height of blade
7
Advertisement
