TecumsehPower TH098SA Operator's Manual page 9

6. Push starter button or turn ignition switch key (see
equipment manufacturer's instructions) to start engine.
If engine fails to start after 3 attempts repeat steps 2 thru 6.
7. When engine starts:
a. Release starter button or ignition switch key.
b. Momentarily move choke control to "1/2 CHOKE"
position until engine runs smoothly. See Figure 9.
c. Next, move choke control to "NO CHOKE" position.
See Figure 9.
If engine starts but falters when choke control is moved to
"NO CHOKE" position:
a. Momentarily move choke control back to "FULL
CHOKE" position. See Figure 9.
b. Next, move choke control to "1/2 CHOKE" position
until engine runs smoothly.
c. Finally, move choke control to "NO CHOKE"
position.
If engine dies after choke control is moved to "NO CHOKE"
position repeat steps 2 thru 7 to restart engine.
8. If engine fires but does not continue to run, move
choke control to "NO CHOKE" position and start
engine.
9. If engine fails to start after 3 attempts in the
"NO CHOKE" position, move choke control to
"FULL CHOKE" position and start engine.
When disconnecting power cord, always disconnect power
cord from outlet first; then disconnect power cord from
switch box on engine. See Figure 8 on page 6. Afterward,
continue reading instructions below.
10. Disconnect power cord from outlet.
11. Disconnect power cord from switch box on engine.
12. If engine does not start after following steps 1 thru 11,
contact your Authorized TecumsehPower Servicing
Dealer. DO NOT attempt to start or troubleshoot this
engine in any other way.
181-807-14
NOTE
NOTES
NOTE
Two-Cycle Engine • Horizontal/Vertical Crankshaft • Air-Cooled
1
2
1. "NO CHOKE" Position
2. "1/2 CHOKE" Position
3. "FULL CHOKE" Position
Figure 9. Choke Control Positions
Figure 10. Primer Bulb
3
Page 7