Bircher RFGate 2.2.NG Translation Of Original Operating Instructions

RFGate 2.2.A
RFGate 2.2.NG
Wireless signal transmission system for safety edges, two channels
Translation of original operating instructions
General
Transmitter
50.8
10.8
1

Safety instructions

Warning: Switch off the operating voltage before working on the
system. Only trained, qualified personnel may perform installation
and startup. The unit may only be repaired by the manufacturer. The
switching unit may only be used to protect against dangers on
crushing and shearing points and on automatic industrial doors and
gates (intended use). National and international regulations on
industrial door and gate safety must be complied with. Always
2

Common application

2.1 Industrial door
Transmitter input 1 corresponds to receiver output 1
i
Transmitter input 2 corresponds to receiver output 2
Receiver
ON
1 2 3 4 5
DIP switch 5 OFF
Receiver
50.8
10.8
Transmitter
Contact
(wicket door)
Safety edges
8.2 kΩ
Transmitter
Safety edges
Receiver
80
consider the safety functions of your application as a whole, never just in
relation to one individual section of the system. The installer is responsible
for carrying out a risk assessment and installing the industrial door system
correctly.
It is recommended to change the batteries every year.
i
2.2 Site entrance gate
Transmitter 1 input 1 corresponds to receiver output 1
i
Transmitter 2 input 1 corresponds to receiver output 2
Receiver Transmitter 1
ON
1 2 3 4 5
DIP switch 5 ON
Transmitter 2 Receiver
Transmitter 2
Safety edges Safety edges
8.2kΩ 8.2kΩ
Transmitter 1
Safety edges
341032D
01/19
1