Advertisement
Quick Links
Advertisement
Related Manuals for Magnum R2 Conversion kit
Summary of Contents for Magnum R2 Conversion kit
- Page 1 25.March.2016 Ebike kit installation manual Manual...
- Page 2 Ebike kit installation manual Battery 36V Light 36V Motor Display PAS Senor Part Name: 1.Brake lever set 2.Display 3.Wheel set 4.Pas disc 5.PAS sensor 6.Controller 7.R2 battery 8. Rear carrier 9. Rear carrier band 10.Thumb shift throttle 11.Charger 12.Display extension cable Some of the above parts are different in different countries, only for reference.
- Page 3 1. PAS sensor&PAS disc installing manual PD-DH2 PS-DH-SSP PAS sensor&PAS disc should be assembled on left side of the 2 kinds of bottom bracket. For 2 kinds of bottom bracket above, need to match special PAS sensor&PAS disc which should be assembled on the right side.
- Page 4 1.2.1. Assemble PAS disc,fasten metal ring to fix it. Fine tune the distance between fix ribbon PAS sensor and PAS disc. The head of PAS sensor should aim at the round hole around the PAS disc. ( SIDE VIEW ) seat tube connect with the connector on controller...
- Page 5 2. Motor wheel installation Inner tube , Tire 2.1. Assemble inner tube & tire on motor wheel and pump up...
- Page 6 If there is disc brake on the rear wheel of your bike, please follow below installation. If not, please jump page 2.2&2.3. 2.2. Remove screws and shim from motor. 2.3. Fix disc brake first, then twist screw. (pay attention to disc brake pad direction)
- Page 7 If there is cassette freewheel on the rear wheel of your bike, please follow installation 2.4 below. If not, please follow 2.5. Cassette Freewheel 2.4. Please assemble cassette freewheel according to the sequence in the picture above. Rotating Freewheel 2.5. Please assemble fix rotating freewheel according to the sequence in the picture above.
- Page 8 2.6. Please pay attention to wheel installing direction after assembling rear wheel according to the sequence in the picture above. connect with controller 2.7. Fix motor wheel, fasten the nut, cover with axle cap and make the motor cable connect with controller.
- Page 9 3. Installation manual for controller Display Motor Pas Sensor 3.1 Connect controller with motor, display, PAS Sensor, battery. Put controller into the controller case. 3.2 Put the battery case into the rear carrier.
- Page 10 4. Installation manual for E-brake lever, Throttle and Display 4.1 Take off the original grip and brake lever, assemble the display, brake lever set, thumb shift throttle in turn from kits, and then instal grip. The side of kit assembling on handlebar are different in different countries, only for reference.
-
Page 11: Display Instruction
5. Display instruction 5.1. Switch on&switch off 5.8. 6KM when power off, press" " display can switch on. when power on, press" " display can switch off. Press "UP" for 2s, bike will run under conditionof electrical power-assisted. when power on, press" " for 3s, display will switch off. 5.2.