Advertisement
Installation & Mounting:
Carefully remove the unit from its packaging. Examine the
unit for transit damage. If damage is found, return the product
to your local dealer for warranty replacement. Do not use
damaged or broken parts. Determine a mounting location with
the least amount of curvature as possible. Also, ensure there is
a clear line of sight for oncoming traffic.
Caution:
When drilling into any vehicle surface, make
sure the area is free from any electrical wires, fuel lines,
vehicle upholstery, etc. that could be damaged
Surface Mounting:
Mark and drill two 3.4 mm holes 3.543" or 90 mm apart. Drill
a hole for the wire exit as needed. Secure in place with the
gasket and supplied hardware as shown in FIGURE 1.
MOUNTING SURFACE
FIGURE 1
L Bracket Mounting:
Mark and drill two 2.9 mm holes 3.937" or 100 mm apart.
Drill a hole for the wire exit as needed. Secure in place
with the L brackets, gaskets and supplied hardware as
shown in FIGURE 2.
FIGURE 2
MOUNTING SURFACE
Offset Mounting:
Mark and drill two 2.9 mm holes 5.827" or 148 mm apart.
Drill a hole for the wire exit as needed. Secure in place with
the offset brackets, gaskets and supplied hardware as
shown in FIGURE 3.
Wiring Instructions:
Important!
This unit is a safety device and it must
be connected to its own separate, fused power point
to assure its continued operation should any other
electrical accessory fail.
The ED5051 Series of directional LED light heads are self flashing. All
wiring should be stranded and a minimum of 22 AWG. The positive
line must have an in-line 3 Amp slow-blow fuse for each directional as
shown in FIGURE 4. Isolate the yellow and blue wires when not in use.
(USER SUPPLIED)
(USER SUPPLIED)
IN-LINE FUSE
(USER SUPPLIED)
+
-
Note: On dual color units only, apply (+) power to the blue
wire for dimming.
MOUNTING SURFACE
FIGURE 3
SWITCH
WHITE -
POSITIVE
(DUAL COLOR
ONLY)
SWITCH
RED - POSITIVE
BLACK - GROUND
FIGURE 4
YELLOW -
(SYNC)
BLUE -
FLASH PATTERN
SELECT (MOMENTARY
TO GROUND)
Page 2 of 6
Advertisement
