Download
Share
Print this page
  1. Manuals
  2. Brands
  3. Jesco Manuals
  4. Light Fixture
  5. Sleek Plus S902
  6. Installation instructions

Jesco Sleek Plus S902 Installation Instructions

Hide thumbs
1
2
3

Advertisement

Quick Links

Download this manual
INSTALLATION INSTRUCTIONS
S902
SAVE THESE INSTRUCTIONS

IMPORTANT SAFETY INSTRUCTIONS

When installing or using this product, basic safety precautions should always be followed including the following:
Read all instructions before attempting to install this product.
1.
Ensure main power is off before installing or wiring this product.
2.
Ensure correct voltage is being used for this product.
3.
Disconnect electrical power before adding to or changing the configuration of the product.
4.
Do not install this LED fixture in damp or wet locations.
5.
Fixtures must be installed by a qualified electrician in accordance with all national and local electrical and construction
6.
codes and regulation
1.
Configure design and layout of the system before attempting to install this product. Do not exceed the maximum run length. Do not exceed the
maximum operating temperature of 122 degrees Fahrenheit. For dry location use only.
Model Number
S902-XX/XX
2.
Install the power supply
Determine location of the power supply or junction box.
3.
Assemble S902 run
If multiple fixtures are being used in a run, you can connect the fixtures together by using the pins found at the beginning and end of the fixture.
The molded housing around these pins are keyed to mate with each other. On the input housing, it has a built-in clip that will latch onto the output
housing. A successful connection will make a "click" sound.
There is a ¼" displacement for every connection, please take that into consideration when determining overall run lengths.
You can also connect the fixtures using our connecting cables, available in 3", 6", 12", 24" and 48" options.
4.
Mounting
(2) 0 degree and (2) 45 degree mounting clips are provided with the fixture. Determine the proper location for the mounting clips and then install the
mounting clips with screws. Then snap-in the S902 fixture onto the mounting screws.
.
Max Run length
20 feet
www.jescolighting.com
Instruction sheet subject to
change without prior notice
Rev 12
4/12/2018
Page 1 of 3

Advertisement

loading

Summary of Contents for Jesco Sleek Plus S902

  • Page 1: Important Safety Instructions

    INSTALLATION INSTRUCTIONS S902 SAVE THESE INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS When installing or using this product, basic safety precautions should always be followed including the following: Read all instructions before attempting to install this product. Ensure main power is off before installing or wiring this product. Ensure correct voltage is being used for this product.
  • Page 2 INSTALLATION INSTRUCTIONS S902 Install Power Connector Insert the proper power connector (S902-PC for plug and play drivers or S902-PC-HW for hardwire drivers) into the beginning of the fixture using the input pins. Then use the other end of the power cord to connect to the driver. Note: If you need longer distance between the driver and the fixture, you can use our DL-PS-EXT-XX extension cables, available in 48”...
  • Page 3 INSTALLATION INSTRUCTIONS S902 Optional – Dimming (0-10V) You can also dim the fixture using our LC-DIM5A or LC-DIM5A-HW 0-10V dimming module following the diagram below. Run System Turn the power on. Check all fixtures to make sure they are running properly. If fixtures are not running properly, check all connections. Instruction sheet subject to change without prior notice Rev 12...