Table of Contents
Advertisement
Service
60
5. Check that the particular event has been enabled in the frame.
• For all events, check that the STATUS switch (Switch 1) on the S2
DIP switch block of the 8900NET module is Enabled.
• For Module Failure-Fixed events:
Check that the MODULE switch (Switch 5) on the S1 DIP switch
block of the 8900NET module is Enabled, and
Check that the
page is Enabled.
CONFIG
• For Power Supply Failure-Fixed events:
Check that the PS1 or PS2 switch (Switch 1 or 2) on the S1 DIP
switch block of the 8900NET module is Enabled, and
Check that the
power supply's
• For 8900NET module Failure-Fixed events, check that the
STATUS REPORTING
page is Enabled.
TION
• For Hardware Switch change events, check that the
SWITCH REPORTING
page is Enabled.
TION
• For Frame Bus Failure-Fixed events:
Check that the FRAME BUS switch (Switch 6) on the S1 DIP switch
block of the 8900NET module is Enabled, and
Check that the
frame's
CONFIGURATION
• For Front Cover Removed -Installed events, check that the
STATUS REPORTING
Enabled.
• For Frame Bus Failure-Fixed events:
Check that the FRAME BUS switch (Switch 6) on the S1 DIP switch
block of the 8900NET module is Enabled, and
Check that the
frame's
CONFIGURATION
• For Cooling Fan Failure-Fixed events:
Check that the FAN switch (Switch 4) on the S1 DIP switch block of
the 8900NET module is Enabled, and
Check that the
page is Enabled.
FIGURATION
• For Module Health Failure-Fixed events,
Check that the MODULE switch (Switch 5) on the S1 DIP switch
SLOT STATUS REPORTING
POWER SUPPLY STATUS REPORTING
page is Enabled.
CONFIGURATION
parameter on the 8900NET module's
parameter on the 8900NET module's
FRAME BUS STATUS REPORTING
page is Enabled.
parameter on the frame's
FRAME BUS STATUS REPORTING
page is Enabled.
FAN STATUS REPORTING
parameter on the slot's
parameter on the
NET CARD
CONFIGURA-
HARDWARE
CONFIGURA-
parameter on the
CONFIGURATION
parameter on the
parameter on the frame's
8900NET Instruction Manual
SLOT
COVER
page is
CON-
Advertisement
Table of Contents
