Advertisement
•
The appliance will keep settings in memory if while plugged in and on standby. They will not
be retained if it is unplugged or switched off at the outlet.
•
Due to this, the appliance may take approximately 60 seconds to resume regular temperature
after being plugged in.
The appliance has a manual thermostat to recover the heating function in the case of abnormal
operation. If the appliance has no power, stops working or does not boil the water, you can reset
the thermostat by using a pin in the reset hole. Unplug and press the reset hole several times.
Then reconnect the power plug and run the appliance for one minute with a temperature setting of
100°C and volume of 000 until it
The appliance is ready for use - set the Temperature and Volume to desired settings.
•
After cleaning the appliance, please open the drainage stopper in order to drain waste water.
Tighten when replacing.
Note: If found water leakage from the bottom, please tighten the drainage stopper.
3. Emptying the Water Tray
Remove the water tray by using one hand to stabilise the appliance and another to lift the water tray
slightly and remove it. Empty the water tray and replace it with medium force.
r each boiling point.
6
Advertisement
