Blast WD3305 Instruction Manual

Instruction Manual
Wireless Game Controller
Appearance and Key List
The image below shows the location of the switches and buttons. Each function is outlined below.
(The illustration is for reference only. Certain controller functions are incompatible with some games.)
1 REWIND
Press the button to rewind gameplay.
2
MENU
Press the button to display in-game menu.
3
START
Power Indicator
5
Press any key and the indicator will light up if there
is still battery power left in the controller.
6 ON OFF
Power
Turn the controller's power ON/OFF.
How To pair the controller with
the BLAST! HDMI dongle
1 2
Press and hold Game
Turn the
key A and Up on
controller's
D-pad. Turn the
power off.
controller's power on.
NOTE : Controller will connect to dongle automatically. Pairing is needed only if the controller doesn't work right or a new controller needs to
be connected to dongle.
How TO confirm the wireless controller
connects to the BLAST! HDMI dongle
1
Insert two AAA batteries into
the back of the controller.
NOTE :
1
If a controller button has not been pressed for a while, the controller will enter standby mode.
Press any button to wake the controller from standby.
Each wireless controller requires 2 AAA batteries, not included.
Controllers from the following previous ATGames consoles are supported: 2018 Blast! consoles (including WD3301, WD3302,
WD3303, WD3304, WD3306) and Sega Genesis Flashback. Others are not supported.
HDMI Dongle
A
7
B
8
C
9
X
10
Y
11
Z
12
NOTE: X, Y, Z functions may
vary depending on game.
3
Keep pressing and After complete Step 3,
use USB cable to
holding Game key A and
connect the HDMI
Up on D-pad until the
dongle and the
power indicator starts
Mirco-USB port on TV.
blinking.
2
ON
Power on the system. Press any
button on the controller and it
will connect to the HDMI
dongle automatically.
4
2
4
Plug the large end of the
USB cable into a USB
port or USB AC adapter
(not included) to turn on
the HDMI dongle.
3
OFF
2.4G Wireless Controller
3
Accessories Information
USB Cable length: 1ft
HDMI Dongle INPUT:5V 500mA
5 6
When the power
indicator stops
blinking, you
have completed
pairing.
The power indicator won't
blink. It will stay on until you
turn it off or it has entered
standby mode.
10
5
6
12
11
9
8
7