Profort combiSpot Manual page 2

combiSpot
Seismic/magnetic detector
Function:
combiSpot is a wireless detector, which contains a seismic sensor and two magnetic sensors. The
seismic sensor reacts to vibrations and it is possible to adjust the sensitivity of the seismic sensor
on the central unit. The two magnetic sensors are activated by means of an external magnet with-
in a short distance. The unit is supplied with an internal battery.
combiSpot contains two magnetic sensors, but one of them has only a sabotage function meaning
that if both magnetic sensors are activated at the same time a malfunction will be registered.
It is possible to use both the seismic sensor and one of the magnetic sensors at the same time. The
central unit program will indicate if the seismic sensor or/and the magnetic sensor must be used.
Assembling:
combiSpot must be placed as high as possible. Preferably so that the antenna is placed either in
the right or left corner of the object, which it is placed on. Note that the end of the antenna must
not be hidden behind metal or reinforced concrete. This considerably limits the reach of the an-
tenna.
To obtain the correct sensitivity
on the seismic sensor the detec-
tor must not be installed with a
down-pointing antenna.
The detector is installed by means of double-sided tape or through the hole.
Service and maintenance:
Every 6 month a check must be made whether or not the detector can be activated. This can be
done either by shaking the detectors or removing the enclosed magnet. Then it must be checked
www.profort.com
The magnetic sensor, which is used, is placed behind the star
in the logo, see diagram. If a magnet is led to or away from
the place, an alarm will be registered. The magnet can be
installed either on the object or on the wall. It is important
that the magnet is placed directly opposite the magnetic sen-
sor.
whether an alarm has been registered from the detector on the central unit. If the detector
doesn't work the battery is exchanged. If it still doesn't work, the entire detector is exchanged.
The detector's battery is ex-
changed by loosening the two
screws at the back of the detector.
The battery is loosened carefully
by the fingers. Hereafter the new
battery is put in. Note that the an-
tenna must be placed so that it is
not squeezed when the cover is
installed.
Specifications:
Dimensions: 79 x 39 x 9 mm
Weight incl. internal bat- 25 g
tery:
Radius of wireless signal: Up to 1000m by exterior
measurement.
Detection distance from
magnetic sensor: Up to 25 mm
Power supply: Battery
Battery life span: approx. 5 years
Temperature: minus 10
sius
Spare parts and accessories:
Detector, 868MHz: Profort number 004720
Battery: Profort number 004029
Double-sided tape 2x5cm: Profort number 299003
Magnet: Profort number 004028
Operating manual: Profort number 104010
o o
to plus 55 Cel-
ver. 3.01