P.L.LIGHT SYSTEMS Alpha Installation Instructions

Installation Instructions
1
Prepare Light Fixtures
• Arrange boxed light fixtures on floor in specified
mounting locations; remove fixtures and mounting
accessories from boxes.
4
Install Lamp
Slide & Lock
• You will have one of two styles of lamp holder
brackets in your fixture: Slide & Lock (above left) or
Twist & Lock (above right).
• For complete lamp installation instructions, see page
3 for Slide & Lock and page 4 for Twist & Lock.
!
© P.L. Light Systems, 4800 Hinan Drive, Beamsville, Ontario, Canada, L0R 1B1 T: 905.563.4133 Toll Free: 1.800.263.0213 www.pllight.com
NXT-LP
2
Insert Reflector into Collar
• Slide reflector into collar at an angle, so that
outer rim is inserted beneath the collar tabs.
Note: Wear cotton gloves or wash hands thoroughly with soap & water
to remove any grime/oils before handling reflector.
5
Install Mounting Brackets
A
bracket mount
locations
Twist & Lock
• Position first mounting bracket so that hole aligns
with relevant bracket mount location.
• Thread screw through the hole in the bracket and
tighten down.
ATTENTION: Install in accordance with national and local building and electrical codes.
Alpha / Beta Reflector: Bracket Mount
3
Insert Reflector into Collar Adjust and Secure Reflector
• Using both hands, adjust the reflector from the
inside, by gently pressing outwards until the outer
rim fits securely beneath the collar tabs on all sides.
Note: Wear cotton gloves or wash hands thoroughly with soap & water
to remove any grime/oils before handling reflector.
5
B
• Position second mounting bracket so that it is facing
the opposite direction to the first.
• Align the hole aligned with relevant bracket mount
location.
• Thread screw through the hole in the bracket and
tighten down.
!
PAGE
1 of 4