Summary of Contents for KWIK GOAL KWIK FLEX 2B1701
Page 1
ASSEMBLY INSTRUCTIONS FOR 2B1701 KWIK FLEX GOAL 1. Unpack all parts and check for damage that may have occurred during shipping. If damage has occurred, notify Kwik Goal immediately. Lay out all parts. Remove all cardboard and packaging immediately. Wet or damp packaging may damage contents.
Page 2
2. Open base frame by swinging outward until button locks in place in center connector as shown. Use care to keep net from getting pinched in moving parts. Base Frame Center Connector Base Frame Open until button locks in place Center Connector Base Frame Base Frame...
Page 3
4. Add tension rods to base as shown. Front or Rear Tension Rod Front Tension Rod (Long) Bottom Tension Rod Rear Tension Rod (Short) Bottom Tension Rod Rear Tension Rod Front Tension Rod Bottom Tension Rod Bottom Tension Rod Left Base NZ403 Rev.
Page 4
5. Connect top corners of net to front tension rod assembly by sliding rod cap over end of tension rod. Rod Cap Assembled Front Tension Rod 6. Connect backdrop corners of net to back tension rod assembly by sliding rod cap over end of tension rod. Rod Cap Assembled Rear Tension Rod...
Page 5
7. Secure corner of net to left and right base with hook & loop straps as shown. Hook & Loop Strap Left Base Go to kwikgoal.com for additional product information. NZ403 Rev. 02/11/19...
Need help?
Do you have a question about the KWIK FLEX 2B1701 and is the answer not in the manual?
Questions and answers