Download Print this page

ADVANCED Network Devices IPCDS-RWB-U Installation Instructions page 2

Double-sided ip display with universal mount

Advertisement

DEVICE OPERATION
1. Connect the other end of the network cable to a PoE (Power over Ethernet) network switch, or a PoE injector, on a
network with a DHCP server. Find some supported equipment options listed at
resources/prepare-for-installation/
2. If properly installed, the unit should boot up and show the time within 30 seconds. See boot sequence below.
3. Consult the IPClockWise User Manual (see
instructions on sending audio and text to the device.
BOOT SEQUENCE
When first powered on, if properly installed, the device should boot, and then display the time as follows:
1
2
3
4
5
6
ADDITIONAL RESOURCES
User Support:
Technical Resources:
AND Limited Warranty:
AND Legal Disclaimer:
https://www.anetd.com/portal/
The first screen you will see. This screen should appear within 1-2 seconds of
powering on the device. The AND jingle should playback over the speakers.
Indicates the current firmware equipped with the device.
Indicates the network MAC address of the device (configured at the factory).
Indicates that the device is looking for a DHCP server, among other things. If the boot
process hangs in this state, check for a possible network problem (cable, switch, ISP,
DHCP, etc.)
Indicates the IP address of the device. DHCP assigns this network-specific address.
Otherwise, the static address will appear if configured as such. An audio beep should
playback over the speakers during this stage.
Once all initialization completes, the time will display. If just a colon displays, it
cannot find the time. Check the NTP server settings, and check that the internet
connection is working.
https://www.anetd.com/user-support/
https://www.anetd.com/user-support/technical-resources/
https://www.anetd.com/warranty/
https://www.anetd.com/legal/
Advanced Network Devices • 3820 Ventura Dr. Arlington Hts. IL 60004
tech@anetd.com
• 847-463-2237 •
Version 1.0
Double-Sided IP Display
(IPCDS-RWB-U) Installation
https://www.anetd.com/project-
) or third-party software guide for further
www.anetd.com
7/18/19
with Universal Mount

Advertisement

loading