Advertisement
Quick Links
BITE ALARM
BITE ALARM
1 Snag Bar
2 Multi-colour LED Lights
3 Tone Dial (5 settings)
4 Multi-colour LED Dial (7 colour options)
5 Power Socket
6 Roller
7 Volume Dial
8 Sensitivity Dial (5 settings)
9 Power Switch (on/off/night light)
BITE ALARM SET
RECEIVER
RECEIVER
10 LED Lights
11 Tone Dial (5 settings)
12 Power Switch (on/off/vibrate)
13 Coding Dial
14 Volume Dial
For technical support contact: info@nextgenerationtackle.com
BATTERY INSTALLATION
Install a 9-volt battery in each of the alarms and the receiver by sliding
down the battery cover plate on the back of each unit.
SYNCHRONISING ALARM SEQUENCE WITH RECEIVER LED ORDER
Step 1 Make sure the sensitivity dial is set to 1.
Step 2 Turn ON alarm and turn receiver OFF.
Step 3
Press and hold the 'Coding Button' on the receiver and turn ON.
Step 4 Release 'Coding Button' on the receiver and press again
to change the LED order.
Step 5 Trigger the alarm and turn receiver OFF and ON.
RANGE TEST
Step 1 Turn ON Receiver.
Step 2 With the bite alarm powered off turn the sensitivity dial to '5'.
Step 3 Turn the bite alarm ON - Audible alarm noise indicates alarm range.
Step 4 Quit the range test by turning OFF alarm.
LOW BATTERY
Each alarm unit utilizes a low battery alarm is indicated by a short beep.
MAINTENANCE
Wipe alarms and receiver unit after each use. Remove moisture and
debris with a dry clean cloth. For long storage periods remove batteries.
Note: NGT Dynamic Bite Alarms are supplied pre-paired.
Advertisement
Summary of Contents for NGT Dynamic BITE ALARM SET
- Page 1 4 Multi-colour LED Dial (7 colour options) 13 Coding Dial 5 Power Socket 14 Volume Dial 6 Roller 7 Volume Dial Note: NGT Dynamic Bite Alarms are supplied pre-paired. 8 Sensitivity Dial (5 settings) 9 Power Switch (on/off/night light) For technical support contact: info@nextgenerationtackle.com...
- Page 2 RECEIVER BIVVY LIGHT OPERATING INSTRUCTIONS Step 1 Remove magnetic bottom plate and lightly twist off bottom cover until it comes loose. Step 2 Remove battery cover, insert 3 x AA batteries and reinstate cover. Step 3 Turn on power by holding the on/off button for 2 seconds. Step 4 If required, adjust brightness by pressing the brightness button.
Need help?
Do you have a question about the Dynamic BITE ALARM SET and is the answer not in the manual?
Questions and answers
I think my new alarms have a problem they are not synced with the receiver
To fix the syncing issue between the NGT Dynamic BITE ALARM SET and the receiver, follow these steps:
1. Set the sensitivity dial on the alarm to 1.
2. Turn ON the alarm and keep the receiver turned OFF.
3. Press and hold the ‘Coding Button’ on the receiver, then turn the receiver ON while still holding the button.
4. Release the ‘Coding Button’, then press it again to change the LED order if needed.
5. Trigger the alarm, then turn the receiver OFF and ON again.
This sequence should resynchronize the alarm with the receiver.
This answer is automatically generated
I have purchased ngt dynamic mk2 **** alarms and can't get the receiver lights to match corresponding **** alarm
The NGT Dynamic Bite Alarms are supplied pre-paired with the receiver, so no manual synchronization is needed.
This answer is automatically generated