KeyLink 01813504 User Manual

Compatible with popular switch ranges
Easy Operation using arrow buttons and display
Week /day program
Astro function
Random function
Sun function, option of connecting lux sensor
Ä
– Contact a professional electrician to install the control system,
because the control system requires a power supply of
230VAC, 50 Hz.
– Check the control system for signs of mechanical damage
after unpacking. If you notice any shipping damage, do not start
up the control system and notify your supplier immediately.
– The control system should only be used for the purpose spe-
cified by the manufacturer (refer to the operating instructions).
Any changes or modifications thereof are not permissible and
will result in loss of all warranty claims.
– If the control unit or the connected sunshade cannot be oper-
ated without presenting a hazard, it must be switched off and
prevented from being switched on unintentionally.
– When performing work on the windows, controls or connected
shades, protect them against unauthorised or unintentional
operation.
– This device contains a pollutant battery. The end user must
recycle all used batteries in accordance with regulation
91/157/EWG. Disposing of the batteries in household waste
is strictly forbidden.
Power supply:
Impulse voltage withstand level: 2.5 kV
Rated power:
Output (Up/Down):
Maximum load:
Align switching time down:
Tilt time:
Software class:
Operating temperature:
IP class:
Degree of contamination:
Battery:
Dimensions (L × W × H):
Colour information:
Mark of conformity:
© KeyLink International
Shutter Control
Art.-no.:
01813504
Short description
Safety precautions
Technical data
230VAC, 50 Hz
< 0.5 W
230VAC, 50 Hz
250VAC, 3A, cos f > 0.8 ind.
3 –120 seconds
0 – 30 seconds
A
0 °C (32 °F) to +40 °C (104 °F)
IP 30
2
CR 2032
50 × 50 × 46 mm (without cover frame)
similar to RAL 9010
p
Shutter Control
Shutter control for manual or automatic control of electric shutters.
Installation and Operating Instructions
Installation
Ä
WARNING!
Risk of injury due to improper installation and commissioning.
Improper installation and commissioning may lead to personal
injury or property damage.
Therefore:
– When connecting the device, observe the currently valid VDE
standards (in particular DIN VDE 0100/0700), your local
power company's regulations and the current accident pre-
vention regulations.
– Connect the control in accordance with the wiring diagram.
Notes for professional electricians
1. In any case ensure that safety regulations according to DIN VDE 0105
are applied.
2. Connect the power supply in accordance with the wiring diagram.
3. Fit the power supply into a deep flush box and fix in place.
4. Fit the frame cover.
5. Fit the operating device into the power pack by applying gentle pressure
to the frame cover.
6. Switch on the power supply.
7. You can test the direction of the sunshade using the "Up" and "Down"
buttons.
Wiring diagram
Ä
ATTENTION!
Parallel control of more than one drive motors can only be
implemented by means of isolating relays and group con-
trol devices.
Note concerning the central input!
i
While an up or down command (activated using the central but-
ton) is being performed, you cannot perform a stop or up/down
command using the control system. Central input is performed in
manual and automatic mode.
1/ 4
G
Art.-no. 01813504
Subject to modifications.