Typical Use Instructions - General Data Healthcare TBS SHURDry Slide Dryer III Series Operator's Manual

5.1.6
HRS
This button places the unit into a set mode. If the clock is currently being displayed,
it causes the hour's button to blink indicating to the user that they may now set the
hours. The hours is then set with the + and – keys on the far right. The set mode will
exit if any key other than the + or – key are depressed. The same is true when setting
the TIMER or individual timers F1-F6.
5.1.7
HEAT LED (RED LED)
These LEDs indicates that the heater is ON. The LED blinks when the heater is
working to reach the set temperature.
5.1.8
LIGHT
This button activates the fluorescent tube light.
5.1.9
START
This button starts the TIMER.
5.2

Typical Use Instructions

5.2.1
Setting Clock Time
Utilize CLOCK button to display time in CLOCK/FILTER LIFE window. Press
HRS button then utilize +/- buttons to increase/decrease hour setting. Press MIN
button to utilize +/- buttons to increase/decrease minute setting. Depress CLOCK
button once to display time in 12 hour format, twice to display time in 24 hour
format. A colon will blink in 1 second increments when clock is being displayed.
5.2.2
Operating TIMER
Press TIMER button to display the timer. The readout is in hours and minutes. The
hours and minutes are adjusted by pressing the HRS or MIN buttons and using the
+/- buttons to increase/decrease the values. The START button is used to start the
timer. The HEAT button interrupts the timer and resets it to the set value. The
bottom decimal, separating the hours and minutes LED segments, blinks when the
timer is running.
5.2.3 Function Key Operation (F1-F6)
The function keys currently serve as individual timers in addition to the main
TIMER. These timers default to the main TIMER setting value. Press and hold the
function key in order to start the timer. Quick press a function key to display the
time remaining on the individual timer. Press and hold the function key in order to
interrupt and reset the timer. Press the function key to stop the alarm when the timer
expires. In addition to the alarm, values T1-T6 are momentarily displayed in the
Temperature LED to indicate to the user which timer has expired.
General Data Healthcare, Inc.
13 | P a g e