CHINESPORT / BA No.: 02.07.084/02-12 Product description Table of contents General advisories Introduction Intended proper use Equipment Warranty Spare parts orders, complaints Re-use, lifetime Disposal Symbol advisories Safety advisories, use Product specifications München Lübeck Scope of delivery Technical specifications Spare parts...
CHINESPORT / BA No.: 02.07.084/02-12 the product without the manufacturer’s permission 1. General advisories automatically lead to the immediate nullification of warranty and product liability (see Maintenance). 1.1 Introduction The delivery date written on the delivery note applies as the valid start date of the warranty In these User Instructions you will find information period.
CHINESPORT / BA No.: 02.07.084/02-12 • To prevent body parts from getting pinched, do 7. Safety advisories for use not reach between the seat and the frame when When using the chair, the following safety pressing the seat into the seat frame.
CHINESPORT / BA No.: 02.07.084/02-12 Dimensions Genf (ca.) A. height 102 cm B. width 73 cm C. depth 100 cm D. seat height ca. adj. 57-62 cm E. seat width 46 cm F. seat depth 45 cm G. clearance * H=43/B=36 cm H.
CHINESPORT / BA No.: 02.07.084/02-12 4. Swivel the armrests to the back, insert the getting should done without backrest into the steel tubes of the chair frame assistance from a care worker. The chair may and push it down until it hits the striker of the not be used for long patient transport times.
CHINESPORT / BA No.: 02.07.084/02-12 Caution – danger of falling! 11.8 Handling the commode pan The patient must not stand on Push the commode pan under the seat from footrests when sitting behind the chair. To remove the pan, lift it up down, getting up, or leaving slightly and pull it out.
CHINESPORT / BA No.: 02.07.084/02-12 Check the function of the wheel brake by pressing the lever forwards. If the brake effect is still not sufficient, then carry out the adjustment steps again (reduce or increase the distance to the wheel).
CHINESPORT / BA No.: 02.07.084/02-12 12. Troubleshooting 14. Maintenance Fault Poss. cause Correction The cause of accidents or damage may be due to the late detection of wear and/or improper use, as Armrests do Locking pins are Clean, check well as irregular or no maintenance.
Need help?
Do you have a question about the Lubeck and is the answer not in the manual?
Questions and answers