Page 1
1825 VIA BURTON ANAHEIM CA 92806 714-772-5202 / FAX 714-772-2302 EMAIL: MAIL@MAJORMFG.COM WEB: WWW.MAJORMFG.COM INSTRUCTIONS FOR HIT-21 DRILL GUIDE FOR INSIDE MORTISE CYLINDER WHEN USING POWER TOOLS ALWAYS WEAR EYE AND EAR PROTECTION!! Copyright 2016—Major Manufactur-...
Page 2
Installing an inside cylinder on an existing mortise lock can be frustrating to center correctly. The HIT-21 will make the job fast, accurate and easy. You don’t even have to take the mortise lock out of the door. Just remove the outside cylinder, thread the HIT-21 into the mortise case until it contacts the mortise cavity on the opposite side.
Page 3
The HIT-21 is used to locate and accurately drill the inside cylinder hole for a mortise lock when retrofitting a single cylinder to a double cylinder lock. First remove the lock faceplate and loosen the cylinder retaining screw. Next remove the outside...
Page 4
Shown at right is a drill with a 1/4” drill bit. The center of the HIT-21 has a hardened steel sleeve. Drill from the outside thru the mortise pocket.
Page 5
When the hole is drilled, remove the HIT-21 drill guide. You will have a perfectly drilled cylinder hole. Install the outside and inside cylinders and replace the lock faceplate. Check for proper operation. That’s all there is to it! Copyright 2016—Major Manufacturing...