Related Manuals for Wijas PERFECT MIX Series
Summary of Contents for Wijas PERFECT MIX Series
- Page 1 INSTALLATION AND OPERATING INSTRUCTIONS PERFECT 3.5, 4.0, 4.5, 5.0, 5.5 MIX instantaneous water heaters...
-
Page 2: Safety Recommendations
1. Purpose and characteristics PERFECT 3.5 – 5.5 MIX instantaneous water heaters are designed to supply hot water to such sanitary devices as sinks and washbasins in households, washrooms, bathrooms, workshops and catering outlets. Thanks to the electronic system controlling the performance of the heater, all most unreliable mechanical parts such as a membrane and switch contacts, which are used in this type of heaters, have been eliminated. - Page 3 – The device cannot be installed in an aggressive environment or the environment exposed to explosion. – The heater should not be used with the load voltage lower than 200 V. – Only original parts can be used. – All maintenance works should be conducted when the device is disconnected from the power source.
-
Page 4: Installation
fig. 2 Installation Caution!!! Each time the device is cut off from the cold water outlet, it must be previously disconnected from the power supply. Otherwise, the heating element may be damaged. Non-compliance with the instructions will lead to the loss of warranty. Firmly screw the half union of the heater (1) with the gasket (2) to the cold water pipe (3) ended with 1/2”... -
Page 5: Temperature Adjustment
fig. 3 tightness of hydraulic connections. Turn on the hot water tap for a few seconds in order to release the air from the heater. Connect the heater to the electrical wiring. Turn on the power supply. 4. Temperature adjustment Caution!!! The outlet water temperature depends on: –... - Page 6 How to adjust water temperature – It is advisable to start the adjustment by turning the knob to the left and pulling it towards you. Then, control the water flow by pulling the knob slowly towards the heater. (fig. 4a) –...
- Page 7 water filter fig. 5 3. Clean the water filter in the half union. 4. Firmly screw the heater to the water piping. 5. Check leak tightness of hydraulic connections. 6. Turn on the hot water tap for a few seconds in order to release the air from the heater. 7.
-
Page 8: Technical Data
Technical data Perfect Perfect Perfect Perfect Perfect Type 3.5 MIX 4.0 MIX 4.5 MIX 5.0 MIX 5.5 MIX Power 230V 50Hz 230V 50Hz 230V 50Hz 230V 50Hz 230V 50Hz Power consumption 15,2 A 17,4 A 19,6 A 21,7 A 23,9 A Heating coil power 3500 W 4000 W...