User Manual - ID-AL Mono Earphone Quick Start Manual

User manual

Connect the 2 wires of the Mono Earphone on the audio
●
amplifier output as a traditionnal speaker.
Caution, if you want to use an audio amplifier, don't use a
high power amplifier otherwise you can destroy the speaker.
(few Watts at maximum)
You can use the mini-jack adapter to connect the Mono
●
Earphone on a standard 3.5mm jack audio output.
All headphone amplifiers are compatible.
Compatiblity with ID-AL range
Direct connection by wire :
NanoPlayer mkII *
●
MicroPlayer mkII *
●
EventPlayer *
●
VP200HD(i) * and VP250HD(i) *
●
Flash mpx SD *
●
NanoAMP1 *
●
* Caution, amplifiers of those models are overpowered. You
need to setup the output volume at the minimum level and
adjust slowly the sound to do not destroy the speaker.
Waves System / ID-AL - La Ville en Bois - 44830 BOUAYE - FRANCE
Mono Earphone
Specification :
Bandwidth : 50Hz - 18kHz
●
● Impedance : 32 Ohms
● Max power input : 250mW RMS
● Size : L150 x W70 x T50 (mm)
● Weight : 250g
Connection with the mini-jack adapter :
●
●
●
●
Accessory kit:
This kit offers a stand and a mini-jack adapter
Tel : 33 (0) 2 40 78 22 44 - Fax : 33 (0) 2 40 78 00 36
e-mail : info@wsystem.com - www.id-al.com
MicroAMP2
MicroAMP4
NanoAMP2
NanoPlayer Headphone
Stand
Amplifier output *
Mono Earphone
Mono Earphone
Mini-jack
adapter
Mini-jack
adapter