Spectracide ACCUSHOT Operating Instructions

Spectracide ACCUSHOT Operating Instructions

Advertisement

People and pets should not be allowed on treated areas until product has dried.

DIRECTIONS FOR USE

Before using, test surfaces to be treated for color fastness by applying to a hidden area. Wait 1
hour, then wipe with cloth. If color is removed from the test area, do not use Nature's Miracle®
Urine Destroyer on those surfaces. Do not use on untreated hardwood, leather, suede, silk or
wool specialty fabrics. Always use this product full strength. Do not dilute. Always use Nature's
Miracle Urine Destroyer products first. Other cleaners and detergents may fail and chemically
"set" stains that will be impossible to remove.

FOR STAIN REMOVAL

1. Wipe up as much of the stain as possible, then thoroughly soak stain with this product.
2. Allow to work for 10 minutes, then blot up stain with a clean cloth.
3. Allow area to dry for 24 hours.
4. For severe, old or stubborn stains an carpeting or fabrics (feces or vomit/hairball),
follow steps 1-2 above and follow with gently scrubbing the stain with a soft bristle brush
for 1 minute, then allow to dry for 24 hours.

FOR ODOR ELIMINATION

1. Wipe up excess odor-causing material, then thoroughly soak area with this product.
Saturation is important so that this product can penetrate deeply to the odor source. In
carpeting, this may mean lifting carpet and applying directly to the pad and floor.
2. Do not wipe up excess.
3. Leave treated area wet and let it air dry. Odor will fade as this product dries. Complete
odor elimination only happens when all odor sources are reached.
4. For severe, old or stubborn odors on carpeting or fabrics, saturate a towel with water and
lay over the treated area, letting sit for 1 to 2 hours. This will allow the bacterial
enzymatic activity to break down and consume more of the odor.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ACCUSHOT and is the answer not in the manual?

Questions and answers

walter watts
February 20, 2025

first time use how to activate battery's

2 comments:
Mr. Anderson
February 20, 2025

To activate the batteries for the Spectracide AccuShot for first-time use, follow these steps:

1. Use a screwdriver to open the battery compartment.
2. Insert four new AA batteries in the correct positions as marked inside the battery compartment. Ensure the positive and negative ends are placed correctly.
3. Do not mix different types of batteries (alkaline, carbon-zinc, or rechargeable). Use a complete set of new batteries of the same type.
4. Securely close the battery compartment door.

This answer is automatically generated

Stan Alekman
April 13, 2025

@walter watts

walter watts
February 20, 2025

will not prime

1 comments:
Mr. Anderson
May 14, 2025

The Spectracide AccuShot will not prime if it is held at an angle. It must be kept level to the ground to prime properly.

This answer is automatically generated

Summary of Contents for Spectracide ACCUSHOT

  • Page 1 People and pets should not be allowed on treated areas until product has dried. DIRECTIONS FOR USE Before using, test surfaces to be treated for color fastness by applying to a hidden area. Wait 1 hour, then wipe with cloth. If color is removed from the test area, do not use Nature's Miracle® Urine Destroyer on those surfaces.
  • Page 2 6. When priming the sprayer, hold sprayer level to the ground. Sprayer may not prime if it is held at an angle. Once primed, it will spray in any direction. HOW TO USE THE ACCUSHOT® SPRAYER  Aim toward target area, and away from people and pets.
  • Page 3 Keep reusable AccuShot® Sprayer. Sprayer can be used with other 1.33 gallon Nature’s ® Miracle stain and odor removing products.

Table of Contents

Save PDF