Table of Contents
Advertisement
QUICK START GUIDE
Door Swing
For Integrated models that are installed adjacent to a wall,
1/2" (13 mm) clearance is recommended from wall on
hinge side to allow the door to open 90°. Allow for
additional space for any knobs or pulls installed on the
integrated panel/frame.
Stainless Steel models that are installed adjacent to a wall
require 2-1/4" (57 mm) door clearance on hinge side to
allow for door handle.
Units have a zero clearance when installed adjacent to
3000 Series
cabinets.
1/2" (13 mm)
90°
Door Swing
Space Required
For any Knobs or Pulls
Integrated
Door Adjustments
DOOR ALIGNMENT AND ADJUSTMENT
Align and adjust the door if it is not level or not sealing
properly. If the door is not sealed, the unit may not cool
properly, or excessive frost or condensation may form in
the interior.
NOTICE
Properly aligned, the door's gasket should be
firmly in contact with the cabinet all the way
2-1/4" MIN
Wall
Wall
(57 mm MIN)
90°
Door Swing
Stainless
around the door (no gaps). Carefully examine the
door's gasket to ensure that it is firmly in contact
with the cabinet. Also make sure the door gasket
is not pinched on the hinge side of the door.
Do not attempt to use the door to raise or pivot
your unit. This would put excessive stress on the
hinge system.
Alignment and Adjustment Procedure
1.
Open door and remove gasket near the hinges.
2.
Using a T-25 Torx bit, loosen each pair of Torx head
screws both the upper and lower hinge plates.
3.
Square and align door as necessary.
4.
Tighten Torx head screws on hinge.
5.
Reinstall gasket into the channel starting at the corner.
6
u-line.com
T-25 Torx Screw
T-25 Torx Screw
Advertisement
Table of Contents
