Advertisement
LOCKING PARAMETER VALUES – USING THE PARAMETER LOCK
The parameter lock function allows you to lock the parameters In Level, Out Level, Dry
Level, Wet Level and the assignment of the Focus fields from changing when you
change preset.
By using the parameter lock, you can easily browse through the extensive set of pre-
sets that comes with the DVR2, without having to change back the locked parameter
with each preset change.
To lock a parameter, simply click on the small lock in the parameter field. To unlock
it, click again.
The parameter lock only affects parameter changes made with the mouse. The param-
eter lock does not affect automation data or preset changes initialized from the host
application. These changes will always pass.
An example: You have inserted the DVR2 on a channel. When you use the DVR2 as an
insert effect, you would probably like the dry part of the signal to go trough the DVR2,
and therefore you'd probably turn up the "Dry Level".
Now, if you browse through a couple of presets, using the up and down arrows on the
right side of the preset name, you will see that most of the presets have the Dry Level
set to "Off". In other words, the Dry Level goes to "Off" all the time – which can
become quite annoying.
And here comes the Parameter Lock. Press the small lock in the Dry Level parameter
field, and the Dry Level will stay at the value that you've set it on – no matter what is
saved with the preset you choose.
Once you touch the parameter or send automation data, the lock will automatically
unlock.
DVR2
/ 15
Advertisement
