Vetra MegaSwitch VIP-802 Series User Instructions

User Instructions for
VIP- 802 Series "MegaSwitch"    
Keyboard, Mouse, Audio and Video Switch
FEDERAL COMMUNICATIONS COMMISSION
This equipment has been tested and found to comply with the limits of a Class A digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference when equipment is operated in
a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at their expense.
CE
This equipment has been tested and found to conform to the directives and standards for a Class A Information Technology
Equipment type and for the Commercial Light Industrial equipment class.
INTRODUCTION
The VIP-802 "MegaSwitch"  Keyboard, Mouse, Audio and Video Switches are available as a full function, Integrated Switch
with keyboard control selection, switching keyboard, mouse, audio, and video. The "MegaSwitch" allows one Workstation
comprised of a PC Keyboard, a PS/2 Mouse, Audio, and VGA Monitor to control and work with one or two PC's.
Note: The "MegaSwitch does not come with PS/2, Audio, or VGA extension cables. They may be ordered from
Vetra separately.
INSTALLATION
There are two main steps to connect the Switch:
1. Connect PC's to Switch unit:
a) Keyboard Connect the keyboard inputs of the PC's to the Switch using 6 pin PS/2 male/male extension cables. Connect
PC#1's keyboard port to the backpanel connector of the Switch marked "PC1 KBD". Connect PC#2's keyboard port to the
backpanel connector of the Switch marked "PC2 KBD".
b) Mouse Connect the mouse inputs of the PC's to the Switch using 6 pin PS/2 male/male extension cables. Connect PC#1's
mouse port to the backpanel connector of the Switch marked "PC1 MSE". Connect PC#2's mouse port to the backpanel
connector of the Switch marked "PC2 MSE".
c) VGA Video Connect the Video outputs of the PC's to the Switch using 15 pin HDD15 male/female extension cables.
Connect PC#1's video output to the backpanel connector of the Switch marked "TO PC1 MON". Connect PC#2's video output
to the backpanel connector of the Switch marked "TO PC2 MON".
Or in the case of the V2, V3, and V4 series MegaSwitch
Connect PC#1's Monitor A video output to the backpanel connector of the Switch marked "PC1 MON A" and connect
PC#1's Monitor B video output to the backpanel connector of the Switch marked "PC1 MON B". Repeat this step for PC's #2,
#3, and #4.
d) Audio (Audio models only)
Connect the Microphone inputs of the PC's to the Switch using a stereo cable male/male with 3.5 mm plugs to connectors on
the Switch marked "TO PC 1 MIC " and "TO PC 2 MIC". Connect the speaker outputs of the PC's to the Switch using a stereo
275 Marcus Blvd. Ste-J, Hauppauge, NY 11788-2022 USA
Tel: 631.434.3185 Fax: 631.434.3516
www.vetra.com email: sales@vetra.com